You're a house inspector, right?
Jason Roehl in Lafayette, IN
>So, do you have a digital multimeter?
The first thing is to check your battery's voltage with the vehicle running, and with with ignition off. With it running, you should see, at minimum, 13.5V. With it off, you should see 12.7V or so across the posts. Anything less on either of those is suspect.
Next, pop off the two vent caps that are on the battery. Use your DMM to measure the voltage between adjacent cells of the battery (just stick the probes down in the acid--it's acid, be careful with it, yada, yada, yada). You should get about 2.1V between each adjacent pair of cells. Again, anything less is suspect. You may even have a 0V reading between two cells, which means the battery has an internal short and is toast.
Third, with the ignition off, take off the negative battery lead and put one probe of your DMM on the lead and one on the negative battery post, with the DMM set to measure current/amps. It helps if you disable your underhood light here, but you should get a reading of less than 100mA, preferably less than 50mA. If you don't start pulling fuses one at a time, replacing them each time, until you get a significant drop in current--that will be your problem circuit.
The problem is that many auto techs today are trained to use these whiz-bang, computerized diagnostic tools that do little more than give a green or red light based on some pre-programmed set of parameters. I recently had a battery giving me fits in my minivan that the Sears tech/diagnostic machine told me was a drain somewhere and the battery was fine because the machine lit a green light. The second time in after the battery was dying once a week, on a whim, I checked the voltage between all the cells of the battery, and found that there was a dead short between two cells. Armed with that knowledge, I was able to get my warranteed, pro-rated replacement.
Hope that helps,
Jason



