Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Taking bets on when this guy loses a body part... *LINK*

Posts

Taking bets on when this guy loses a body part... *LINK*

#1

Taking bets on when this guy loses a body part... *LINK*

Dan Mitchell

>Table Saw Insanity, courtesy of YouTube:


http://www.youtube.com/watch?v=Yp-bQQl3FWY

Re: Taking bets on when this guy loses a body part... *LINK*

#2

Too late for a Darwin Award. Unreal.

Jim Toews - Walla Walla, WA

>

Re: Taking bets on when this guy loses a body part... *LINK*

#3

Dale Lenz

Re: Hope...

Dale Lenz

>his little girl is not in back of him while he saws. The guy probably does not know any better about trapping the wood between the blade and fence. Is there a way to respond to him on?

Re: Taking bets on when this guy loses a body part... *LINK*

#4

More worried about anyone around him

Chuck in ND

>I thought the same thing Dale, it's almost a miracle that the board didn't kickback.

Re: Taking bets on when this guy loses a body part... *LINK*

#5

This one raises hairs on my neck

Nathan

>A luthier sawing a veneers off the top of a board using a horizontally spinning saw-blade mounted on a shaper. No safety aids whatsoever.

http://www.youtube.com/watch?v=TiJGmwyYK8k

Re: Taking bets on when this guy loses a body part... *LINK*

#6

OMG

Jim Shaver - Oakville, Ont

>And he used the fence on a cross cut..... Where was that sweet child, I hope she was upstairs and out of range.....

SO this proves , mindless creativity and technology can mix, well for awhile till the law of the jungle depletes it's reservoir of participants one by one... who was holding the video cam as well,

Jim

shaking my head

Re: Taking bets on when this guy loses a body part... *LINK*

#7

This guy has always been my favorite daredevil :O)

Scott in Montana

>

Re: Taking bets on when this guy loses a body part... *LINK*

#8

Alan Young

I saw this a while back-no pun intended

Alan Young

>and then just last night my wife had one of those ubiquitous fix your house in 30 minute shows on---they showed the "carpenters" out back.

Camera angle down even with spinning blade on contractor saw.. The guy throws a sheet of MDF on the saw and it bounces as he pushes it up and through the blade...quick camera cut to smirking face..."Twenty minutes ago I couldn't spell carpenter..now I are one!" buzzzzzz

Alan

Re: Taking bets on when this guy loses a body part... *LINK*

#9

Ditto that.... where's the test?

Mark Goodall - ATL - tooljunkie

>Part of me figures if he's THAT stupid he's bound to get hurt sooner than later, and the cleansing of the gene pool will continue.

...... but I'm horrified that his little daughter was in the line of fire !!!

And who was filimg this? His wife? (shame on her).... No, it couldn't be his wife... even the least intelligent wife/mom has enough sense to realize when their spouse is doing something that idiotic..... and then the mom-sense will kick in and protect the child. So it must have been another child (shudder) or hopefully just another dumb friend.

It's bad enough that someone would do this, but what exactly is the point about FILMING it anyways? I don't get that at all. If it was another one of those thousands of "Hey, look at me" idiot videos filmed by a bunch of half-drunk rednecks, I'd understand, but he seemed fairly serious... and his daughter was right there.

Geeze..... you need to take a test to be a taxi driver, to drive a car, to swim in the deep-end, to enter pre-school.... but there's no test before you can become a parent.

Sigh... I pray the little girl doesn't get hurt or witness a gruesome accident.

Happy Woodworking!

Re: Taking bets on when this guy loses a body part... *LINK*

#10

"And I'm not saying this is safe or anything."

John E in SC

>Now there's a true quote if I ever heard one. The only saving grace is at least as far as I can tell, the little girl was not there when he actually made the cut - if you look, when the little girl was there, the motor was torn apart, and he had on a different shirt than when he made the cut. He may find out real quick crosscutting with the fence in place is a bad idea! (and it looks like from his hand placement that he was actually pushing the board against the fence, not the miter gauge!)

But the biggest thing that makes me go "HUH??", is why in the world would you feel the need to film this and share it with the world? Is he proud of himself for getting that piece o' crap tablesaw running? I know I've done a few stupid things in my day, but I've just never felt the need to share them with the world!

Stay safe,

John

Re: Taking bets on when this guy loses a body part... *LINK*

#11

Re: Taking bets on when this guy loses a body part

Craig in Silverdale

>From the sound of the cut, the blade must be 40 years old also. I've had my Craftsman table saw for 31 yrs and it is in excellent shape. In fact, I wish I looked that good.

Re: Taking bets on when this guy loses a body part... *LINK*

#12

Re: Ditto that.... where's the test?

Larry in NW Ohio

>You say something about his wife would stop him if she saw him doing something stupid, but remember, SHE MARRIED HIM. Larry in Ohio

Re: Taking bets on when this guy loses a body part... *LINK*

#13

Re: This one raises hairs on my neck

Chuck in ND

>You got that right Nathan, thats equally as bad.

Re: Taking bets on when this guy loses a body part... *LINK*

#14

With the regularity of this on various forums...

John in NM

>and all the attention it gets every single time, I'm betting the guy is just looking for the maximum number of hits on his video.

Re: Taking bets on when this guy loses a body part... *LINK*

#15

Re: With the regularity of this on various forums.

Fred Davis

>As the Comedian Ron White often says "you can fix stupid" , but I bet someone in that persons family or a police officer could show that clip to the state CPS and ask if they were as interested in preventing child endangerment as they are in collecting thir paycheck.

FredD

Re: Taking bets on when this guy loses a body part... *LINK*

#16

I couldn't watch it all..Weak stomach here

Victor P

>

Re: Taking bets on when this guy loses a body part... *LINK*

#17

Geez, from all the comments…

Rod Peterson -- Ormond Beach

>…I thought he was hand holding a router with a panel raiser at full speed or free handing on a shaper with no collar. There was only one thing I didn't care for, and that was using the fence with an over-square work piece. All the rest of the stuff was pretty low risk. Hey, he had the blade fully retracted for start up. And it's not like he's not trying to be safety conscious—he mentioned it in practically the first words out of his mouth.

You know, we're pretty cavalier, we grizzled old ww'ers, but almost all of us started by ourselves with little to no mentoring, and there were lots of things we all tried that we found out weren't such good ideas. Who among us could intuitively divine that using the fence on an oversquare cut had the potential for launch? Not until we'd either experienced it (which would make us no better than the guy being railed on) or heard about it would it come up. I'd say give the guy a break. He's no worse than most of us have been at one time or another.

Best yet, let's find him and take him under our wing. I'd be glad to have another woodworker around that's trying.

Children and Family Services? Give me a break. Talk about over-reaction. You don't even know the kid's still in the room.

By the way, that's my old Craftsman Model 100 he's using (not actually mine, but it's the same thing), right down to the crappy fence and the miter gauge.

Rod

Re: Taking bets on when this guy loses a body part... *LINK*

#18

Re: Geez, from all the comments�

Barry Irby

>I agree. Sort of reminds me of the rent-a-cop at some store that arrested a woman because she took her kid out of the car seat and set the carrier down beside the car. Wind blew a $50 out of her purse and she ran around trying to catch it. Cop busted her for abandoning the child and leaving it in danger of being run over. Mind you, the child did not get run over, he just thought there was a danger. Why the H could he have not stood beside the tyke until the lady caught her money, or maybe he could have fetch the money telling her to stand by the child. If I were the store manager I would have fired him for his crappy unhelpful attitude. Bad press.

I still remember learning about "captive" pieces between the fence and blade. Almost set me on my butt. In the forty years since, never again. Find the guy and help him. Invite him to Wood Central. Heck, JL is compiling a list of stupid stuff.

Re: Taking bets on when this guy loses a body part... *LINK*

#19

Did that very thing.

Rod Peterson -- Ormond Beach

>> Find the guy and help him. Invite him to Wood Central.

I wrote him a note from the profile information on the video and told him the oversquare crosscut against the fence was not a good thing to do and suggested he check out some of the woodworking groups. Specifically mentioned us.

Rod

Re: Taking bets on when this guy loses a body part... *LINK*

#20

Re: With the regularity of this on various forums.

Fred Davis

>Ron White says " you can't fix stupid" or my typos apparently

FredD

Re: Taking bets on when this guy loses a body part... *LINK*

#21

Re: Taking bets on when this guy loses a body part

Fred Davis

>Well Dan,

you probably wouldn't have to wait long to collect .

I wondered what he was doing when he got the divot in his chin?

Waiting until a child is maimed because the child had the bad luck to be born into a family whose father is willing to put his kid at risk, so he can have some attention , even if he has to film it and put it on the internet is unacceptable in any society.

Saying your stupid at the start doesn't get you off the hook. Notifying authority when you see a child put at risk is what a responsible adult would do , not applaud the dimwit for surviving his own mischief.

People who do that like the film "Jackass"

Looking at the clip and his shenanigans with the motor would scare the hell out of anybody with common sense.

I personally never subscribed to the notion that one had to put ones hand in fire to discover it was hot and would burn you. Common sense will tell you in advance.

If your missing some body parts because of your own inattention to the job at hand, it is your own fault , not a act of God , or a accident or bad luck.

Bragging about it and comparing injuries is not exactly like comparing war wounds , the latter was unavoidable and the former a measure of your intellect.

Child Protective Services will take a child out of a home for something as trivial as a spanking when needed , so you can imagine their view on something as potentially dangerous as the clip Dan brought to our attention.

Anybody want to volunteer to replicate the part about starting the motor up ??

FredD

Re: Taking bets on when this guy loses a body part... *LINK*

#22

Re: Taking bets on when this guy loses a body part

Chuck in ND

>Yep, I never done anything stupid, or had a bad day in the shop. I looked at the video again a couple more times and either the girl was gone, or she was in a safer corner. The guy definatly looks like he's new into the world of woodworking, so now he's going to learn like the rest of us did, HOPEFULLY !

Re: Taking bets on when this guy loses a body part... *LINK*

#23

Re: Taking bets on when this guy loses a body part

JEB

>But at least he had steel toed shoes on - NOT!!

Re: Taking bets on when this guy loses a body part... *LINK*

#24

What's the big deal? I've seen a lot worse!

Dave Tenney

>What this guy did was a no no, but hey...we've all been there. It isn't even in the ballpark compared to some of the crazy things I've seen done on job sites.

I can tell you that I've done and still do things with a table saw that would make some people a nervous wreck.

Dave

Re: Taking bets on when this guy loses a body part... *LINK*

#25

Re: What's the big deal? I've seen a lot worse!

Fred Davis

>I'm listening

FredD