Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Electrical engineer . . .

Posts

Re: Electrical engineer . . .

#26

Re: Electrical engineer . . .

ken stephens

>In the hospital where I work we use SS plates. I was told it was because if the metal plate screw came loose andthe plate fell between the receptacle and the cap attachment(cord plug) it would hit the ground and not short the neutral to the hot. In 30 years there I did see it happen one time when the ground was on the bottom.

Re: Electrical engineer . . .

#27

Paper clip fell into an outlet

Stephen in Frankfort KY

>I saw a paper clip fall into an outlet with the ground down once. Lots of sparks and a tripped breaker. Since then I've installed outlets ground up.

Re: Electrical engineer . . .

#28

I've always assumed

Larry Marker in Alabama

>that the electricians that install them ground up do so because it's easier to attach the ground wire to the green screw with the screw up.

All of my angled plugs are built for ground down except the refrigerator.

Larry

Re: Electrical engineer . . .

#29

Funny Thing Is

GalenV

>You can still have "fun" droping dimes or paper clips or anything metal in most of your home outlets grounded type or not. Not very many lamps, clocks, televisions, radios,kitchen appliances, sweepers and many small plastic housed shop tools are equipt with a grounding plugs anyway, but are just polarized. All would still operate if you clipped the wide prong to put the plug in an outlet and a lot of older homes you still find that done that do not have polarized outlets.

And how many people are guilty of cliping off the ground prong or using an adapter to go from grounded to two prong. Like where do you connect the ground pigtail on an adapter when the electrical outlets boxes are plastic, old bakelite, or metal and just not grounded?

How many people have put newer grounded outlets in an older home that they had no ground to connect anyway but got what is normally available.

Interesting to read the other thoughts anyway.

I admit to all of the above and still alive today.

Galen

Re: Electrical engineer . . .

#30

Re: My thoughts and a question

Richard Jones

>Fred,

Interesting about CA. Can you cite that code section, can't seem to find it.

I remember a few years back that an Oriental couple did not want the front and back door to line up in the same plane, as they feared that any good luck coming into the house would have to easy an exit path to the rear...........

Rich

Re: Electrical engineer . . .

#31

Re: My thoughts and a question

Fred Davis

>Rich , if your living out there call your local building department or Electrical contractor, they can give you chapter and verse.

For at least the last ten years I ran work or actually did some , ground up was code and checked on final inspection .

I seriously doubt they reversed the requirement for some of the hilarious reasons put forth on this thread.

The State of Ca. could have mandated it , since it has the power and regularly uses it to upgrade code , like UBC, NEC and National Plumbing and Mechanical codes as it sees fit.

Like all codes they are minimum requirements.

FredD

Re: Electrical engineer . . .

#32

Now I'm confused, Fred. Which is it . . .

Henry Higginbotham

>. . . up (this post) or down (previous post)?