Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Drilling Cast Iron?

Posts

Drilling Cast Iron?

#1

Drilling Cast Iron?

Tony - Memphis

>I need to install my old Brett Guard on a new saw with cast iron wings. Seems like I have read that there are tricks to drilling cast iron? I figured it'd be worth asking before I start making a mess of my extensions! Thanks for whatever help. The Brett Guard has a stamped steel base plate that bolts to the wing via two 5/16" (I think) bolts, so we're talking good sized holes here. The cast iron wing is not terribly thick.

I have been using the stock guard and it is ok, but I really miss the Brett Guard. One thin is that it is low profile. When I am trying to cut stock that is 3" or less, there is not much room for my hand and push stick. Becomes very awkward. I never rip without a guard.

Thanks,

Tony

Re: Drilling Cast Iron?

#2

Re: Drilling Cast Iron?

Bill Tindall, E.TN

>I'm no machinist so maybe there is something I haven't discovered, but any time I have drilled cast iron it has been about as easy as drilling wood, actually more so because the chips clear better.

Re: Drilling Cast Iron?

#3

Re: Drilling Cast Iron?

Rob Stokes in North Vancouver

>No tricks. Just let the drill do the work, clear the chips out and make sure you use a bit of light oil in the hole.

Rob

Re: Drilling Cast Iron?

#4

Re: Drilling Cast Iron?

Bill White

>All the old dudes (like me) used to use lard as a lube.

Bill

Re: Drilling Cast Iron?

#5

Re: Drilling Cast Iron?

Jim Dillon

>Tony,

And make sure you have a nice sharp bit. In fact, it might be worthwhile buying a new one just for this job. I went through this while installing my Brett Guard and sure wish I had following my own advice. It was a grueling process until I got a new bit, naturally on the next to last hole while also attaching an outfeed table to the cast iron TS top. Live and learn. BTW, I love my Brett Guard as well.

Jim

Re: Drilling Cast Iron?

#6

Re: Drilling Cast Iron?

Pete LaBelle

>Carefully prick punch your starting point to keep the bit from wandering, then have at it with a high-speed drill bit. Around 5/16" diameter? 6-900 rpm is adequate. Shouldn't need cutting oil on cast iron. Your chips will look like iron saw dust.

Re: Drilling Cast Iron?

#7

Thanks!

Tony - Memphis

>

Re: Drilling Cast Iron?

#8

Cast iron is self lubricating

Robin Corell in Atascadero CA

>Cast iron is has a fair amout of graphite in it due to how it is made/melted. this will also make the swarf from the hole turn everything it gets near black.

Robin

Re: Drilling Cast Iron?

#9

Grey cast iron or ductile cast iron?

Alexander Grigoriev

>