Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Premium Domestic, Figured & Live Edge Hardwoods in Stock. Best Prices for Serious Woodworkers.

Band saw lubrication

Posts

Band saw lubrication

#1

Band saw lubrication

Nikos Annitsakis

>I have a Delta 14" bandsaw, about 8 years old, which has not been used for the last 6 years. In the first two years I used it lightly.

During the 6 year hiatus it was not under tension. The other day I installed a 1/2" band and tensioned it. Then, with the power unplugged,

I tried to turn the wheels by hand and it took some effort to get them going.

The user's manual says nothing about lubrication. Are there any points that may require lubrication, or are all bearings sealed in such saws?

Should I expect that things will mellow with use?

Nikos

Re: Band saw lubrication

#2

Re: Band saw lubrication

GalenV

>My saw is not like yours but when I put a new drive belt on this year I found the motor had oil type ports marked but nothing in my manual to say it needed oil. Look at the motor and see if so marked.

New belt was from my unit settng at least that long while living in a apartment. Bearings for me seemed to be OK as so far been able to cut bowl blanks and that is hard work on mine unit.

You can always track down where the drag is. Take off the blade and turn the upper wheel and see if it is free. Take off the drive belt and turn the bottom wheel and see if it has drag. Then turn the motor and see how much drag it has.

It can be hard on the bearings to site that long as even if you removed the blade you probably left on the drive belt that put load on the lower wheel bearing and the motor.

Galen

Re: Band saw lubrication

#3

Re: Band saw lubrication

Dick Coers

>The blade guides aren't too tight on the blade are they? I would take the blade back off and then turn each wheel seperately. Then if the bottom wheel is the tough one, I'd take off the drive belt. Now you know exactly what is acting up and can concentrate on getting that part loosened up.

Re: Band saw lubrication

#4

Re: Band saw lubrication

John K Jordan

>Nikos,

If I remember correctly, that saw uses shielded upper wheel bearings, not sealed. It's conceivable the bearings could have rusted, but if the moisture was high in storage other things would have rusted too, such as the table, etc. Perhaps grease in the bearings has gummed up. If other things turn easily as Dick suggested checking and a bearing on one or both wheels is not free, you could always replace the bearing. Might be hard to lubricate properly.

JKJ

Re: Band saw lubrication

#5

Re: Band saw lubrication

Robin Corell in Atascadero CA

>It sounds like you might have too much preload on the thrust bearing. try tilting the top wheel until the blade just starts to moove away from the trust bearing and see if that dosent make things spin a bit easier. adjusting the top blade tilt should actualy be part of the process of installing any new blade on a band saw.