Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Super Resolution Thermal Imaging Camera

breadboard edge

Posts

breadboard edge

#1

breadboard edge

David

>After following an earlier thread on breadboard edges I thought seek the group's wisdom once again.

I thought I was through designing a kitchen/dining room table until I watched the Woodwright's Shop a few weeks back where St. Roy made a book stand using lock joints, basically breadboard ends with through tenons. Really cool. I was wondering about the wisdom of this kind of joint, or a mitered breadboard, for a table top that will be approximately 72x40. Here's a rough approximation of what I'm thinking (forgive my poor skills with sketch-up).


I was originally going to use cherry but was just given a load of ash and pulled 3 or 4 wide boards. Moisture content is 8-10%. My concern is that the end boards may split where I cut the miter. I was thinking I'd have to use a blind tenon in the miter as well as the straight section of the end. FWIW I have no problem with end grain. Just thinking of ways to play and make life all that more difficult.

Collective wisdom please?