Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Assembling, leveling cantilevered shelves

Posts

Assembling, leveling cantilevered shelves

#1

Assembling, leveling cantilevered shelves

Jay Crutzfeld

>In the process of assembling a 6' cantilevered entertainment center made of solid ash uprights routed through 3/4 plywood shelves (with 1'' ash facing). The uprights lean backward onto the wall with no additional mechanical bond (nothing is attached to the wall studs). The shelves are fixed to rails running front to back that are attached to the uprights. The center span is 43 inches. The two upper shelves will have additional support from single lengths of 3/4 angle steel to prevent sagging below the centerlines. The bottom shelf (which will hold a 90 lb television) will be supported by a 1 x 8 inch piece of (4/4) ash. The rails for bottom shelf will be attached to the uprights with lag bolts (not through bolts), the upper rails will have screws. The boards are bowed up noticeably, making leveling a challenge. Wondering whether the downward deflection of the shelves over time will put too much lateral pressure on the uprights as they settle onto the underlying supports and if there is a good way to accommodate that movement. Also, the bows and slight warps in the shelves makes leveling with a spirit level or laser difficult, so we are having to fine tune the levels by eye. Wondering if there is a better way.

In the attached picture, the project is supported temporarily with clamps and two stools.


img

Re: Assembling, leveling cantilevered shelves

#2

Attach it

Ed Mulligan, Cape Cod

>Jay -

If this was my project, I would attach it to the wall. Floors bounce as people walk by, possibly destabilizing the shelf. Children climb where they're not supposed to climb. Tipsy cousins try to sit where they shouldn't. You could place the attachment points behind one of the upper shelves so it's not obvious. It sounds like there is very little rigidity side-to-side in your design. If so, the whole thing might collapse sideways. That's a very good reason to attach it to the wall.

Regarding getting the shelves level, it appears that you are building the unit in place. Instead, attach the shelf supports to the uprights using measurements and a bevel square to get the correct angle. Then take it apart, construct in place, shim one or the other upright so the base is horizontal, plumb the uprights, and attach the unit to the wall.

Ed

Re: Assembling, leveling cantilevered shelves

#3

Re: Assembling, leveling cantilevered shelves

David

>I actually had a couple of sets of commercially made shelves that were basically the same as what you're building (except tubular metal uprights).

There were indicator marks on the uprights for placing the shelf brackets. The brackets were essentially circular clamps with wings (from to back) through which you put screws into the underside of the shelves. I think I'd approach this one the same way, i.e., measure down from the top and mark off the uprights.