Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

ADVERTISE HERE - FREE TRIAL

Tall clock design - door thickness?

Posts

Tall clock design - door thickness?

#1

Tall clock design - door thickness?

Scott in Douglassville, PA

>Hi, all -

Well, work on the inlaws' Christmas present progresses. I've begun planing down the rough pine boards (sneeze-city), and have the material for the waist ready for sizing and joinery. In looking ahead, though, I see that, while the Nahm plans spec 3/4" stock for the waist and most of the bonnet, the bonnet door is spec'd at 7/8" thick stock. Any idea why? I'd think 3/4" material would support the glass in the door just fine, and mortise and tenon joinery would be adequate with stock that thick. At best, I can get 3/4" material out of this wood - I'd rather not buy anything, as I want to tell the folks that all the wood in the clock is their dear old pine paneling.

What say y'all?

Thanks,

Scott

Re: Tall clock design - door thickness?

#2

Re: Tall clock design - door thickness?

George@Colonel's Workshop-Havertown PA

>Good Afternoon Scott,

I agree based on my own experience. I used 3/4 stock to construct both the grandmother clock doors. Each of the clock doors were partial overlay, and had 3/8" rabbets. It worked out pretty well. My materials were QSWO and Cherry. Should be fine in pine. Its a small enough component, light but surely strong enough when glued up. FWIW, our joinery was small biscuits and glue. I didn't think a small door needed MT joinery even though it was going to support the glass.

George

Re: Tall clock design - door thickness?

#3

Re: Tall clock design - door thickness?

Howard Norman

>I have a commercial Barwich tall clock that I have owned for 35 or so years. The door measures just under 3/4" think.

Re: Tall clock design - door thickness?

#4

Re: Tall clock design - door thickness?

Larry in NW Ohio

>Scott For what my suggestions are worth, I have already put the door together and ready to put the glass in and if I thought if it needed more support I would drill a 1/4" hole into the side to catch both rails and then put a 1/4" oak dowel in it. But first make sure it was glued up in the corner, that way it will not move or shift, or you could put a screw in the corner to catch both rails. It has worked very well for me in the past. I hope I read your post correctly. Good luck. Larry in Ohio

Re: Tall clock design - door thickness?

#5

Re: Tall clock design - door thickness?

Warren in Lancaster, PA

>Scott, it looks to me as if there is a pretty good molding around the inside edge of the door, perhaps 3/8 in depth. Generally the tenons were put completely behind the molding to keep the sawing away from the molding. Especially if the joint is coped. So maybe there was 3/8 or 5/16 of molding then 1/4 or so of tenon and then 1/4 behind the tenon, making a thickness of 7/8. If you cut up the four boards for the frame and then plane them individually, you might get a little more thickness out of them.

Re: Tall clock design - door thickness?

#6

Thanks, guys...

Scott in Douglassville, PA

>I appreciate your input. I think I'll dice up a board to get some clear, knot-free wood, then plane it by hand to try and maintain thickness. If I can't keep it thick enough, I may make a scratch stock for the bead instead of using a 1/4" beading bit in the router. Would save a bit on thickness.

Out to the garage!

Scott