Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Nearly 100 Exotic Wood Species, Direct-Imported Since 1972. Shop Slabs & Turning Stock.

Curio cabinet

Posts

Curio cabinet

#1

Curio cabinet

Larry in NW Ohio

>My daughter in law asked me to build her a curio cabinet to put some of her momentos in and ask for it to be about 2`deepX4`longX3`wide. Well I made the bottom and glued together the top, after I put them side by side it looked kind of BIG. Being that I`m not very good at sizing things untill it`s all put together, I thought it would be best to ask the collective what you think. Do you think this is out of proportion somewhat? Should it be a little less deep, something like 18" give or take? Or would the 2` from front to back be OK.Thank You Larry in Ohio

Re: Curio cabinet

#2

Re: Curio cabinet

Bill Tindall, E.TN

>2' deep seems too deep to me. It will be hard to seen anything in the back of it. I would think 10-12" more appropriate.

I find I can judge proportions from scaled sketches. Or lacking that, make a model from card board.

Re: Curio cabinet

#3

Re: Curio cabinet

George@Colonel's Workshop-Havertown PA

>Hello Larry,

I tend to agree with Bill, although I'd be shooting for 12-14 inches in depth. That reduction will make the other two dimensions more agreeable. You need another conference with your DIL, and show her with a tape measure what it will look like. Then let her decide.

George

Re: Curio cabinet

#4

Re: Curio cabinet

Larry in NW Ohio

>Thanks fellas, I was thinking thatI`d try about 16" and start from there. But I think it`ll end up around 14. Thanks again. Larry