Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

Sanding hardwood floor questions?

Posts

Sanding hardwood floor questions?

#1

Sanding hardwood floor questions?

Barry Irby

>I have been sanding some oak flooring I patched in an old house I am working on. Using a Silver Line drum sander with an 8" wide drum about 6" in diameter. It has wheels in the back and the drum in the front. Tip it forward and it sands, tip it back and it lifts the drum. I have about pulled both arms out of the sockets fighting with this thing for two days.

Am I using the wrong technique? Can you describe a way that makes it both effective and easier? I have been hold the handle up and pulling back on it at the same time. It cuts more aggressively if I pull it backwards. Would it be better and easier to just restrain it and let it drag itself forward?

Re: Sanding hardwood floor questions?

#2

Re: Sanding hardwood floor questions?

Mike Fitterling

>I don't know that particular sander, but what I do is to let the machine walk itself along while keeping a bit of resistance by holding the handle. If that is too aggressive for you then switch up to a finer grit.

Good luck,

Mike

Re: Sanding hardwood floor questions?

#3

Re: Sanding hardwood floor questions?

Ralph Ambrosio

>The machine you are using is 15 amp? It is not a professional quality tool and is difficult to master. You will probably have chatter because it isn't heavy enough to handle oak. My father had a Clarke 8" clam shell 220v beast, that was easier to use than the machine you are using. Do you think you could scout around for a machine that at least has a drum lift...that is a handle that permits you to lift the drum to feather your passes.

Also, some of these machines have a tension lever that can be adjusted to "lighten" the pass. If this is a rental, someone might have "adjusted" the machine to full tension.

Good luck.

Oh, take a look at this website for sanders. www.ussander.com

Re: Sanding hardwood floor questions?

#4

Re: Sanding hardwood floor questions?

Chuck in ND

>I'm not familiar with that particular sander but the machines I've used all have a lever on the handle, kind of like a clutch handle on a motorcycle. To lift the drum you squeeze the handle. Ofcourse when you lower the drum you ease into it while moveing the sander forward. It takes some practice, if your not careful you can leave some pretty nast dips in the floor. As with any belt type sander you need to know what your doing and don't try to rush the job.

Re: Sanding hardwood floor questions?

#5

Re: Sanding hardwood floor questions?

Glenn Madsen near San Francisco

>I used such a beast 30 years ago. It wasn't my finest hour. The pine floor looked pretty decent with a rug in the middle, but other than that, it was about adequate for a back bedroom, which was what it was.

The last floor we did, we rented what looks like a machine with 4 random orbital sanders mounted in a very sturdy metal box. It was not as fast, but it was much more controllable for hobbyists. I'm pretty certain it came from HD, but that was the responsibility of one of my buddies. I was doing cabinetry and trim on that job.

We didn't need to go down to 36 grit with ours. 60 was fine, and then 80, and finish...