Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This $39 jig will make you a WOODWORKING GOD!

Repairing block plane question

Posts

Repairing block plane question

#1

Repairing block plane question

Barry Irby

>I have a block plane I bought when I was a kid, maybe forty years ago. I think it is a Stanley, but I am not sure and it is on the job and I am not. Last week someone stepped on it while I was repairing hardwood flooring. The screw that holds the "frog" (?) in place is stripped and the little curved slotted piece that opens and closes the throat is broken. (The little pin is missing.)

Is the frog the part that clamps the blade? IF not, what is it called.

Where can I buy parts?

Re: Repairing block plane question

#2

Re: Repairing block plane question

Fred Davis

>Sounds like a Stanley model 60, either high or low angle, parts are the same.

The screw holds down the "cap Iron".

Many sites on the internet with Stanley plane parts.

FredD

Re: Repairing block plane question

#3

Re: Repairing block plane question

Glenn Madsen near San Francisco

>A couple of photos posted on the hand tool forum will put your challenge in front of some real hand tool wizards. The photos will help them be certain of who the manufacturer was. Surprising how many of these folk have spare parts, or sources, available, too.

There's a funky old Stanley in the cupboard in the shop here, too. Sharp, but rusty, and broken cap piece, too. There are a handful of newer, brassier, made in Maine hand planes in the user area, though. The old guy came out of my dad's tool chest...

Re: Repairing block plane question

#4

Re: Repairing block plane question

David

>Depending on which model, Highland Woodworking has rebuild/repair kits for Stanley block and bench planes.