Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Halogen Lights

Posts

Halogen Lights

#1

Halogen Lights

Larry in NW Ohio

>I have one of those stand alone halogen shop lights for finishing and such in my shop. The question is whenit`s being used for an hour or so they get so HOT that over time they burn out, but it`s not the filement inside the bulb, but the ends crumble from the heat. I got a small squarrel cage fan and blow air on them to try to keepit a little cooler, it helps but does anyone else have this trouble and what do you do if anything. Thank You Larry in Ohio

Re: Halogen Lights

#2

Re: Halogen Lights

Bill Tindall, E.TN

>My daughter used to do search and rescue and they kept halogen lights on for hours. I have them around the barn and I have had these on for hours during wee morning hours lambing. I suspect your problem is poor quality, not flawed concept.

Re: Halogen Lights

#3

Re: Halogen Lights

wilbur

>Not having used halogen lamps in my shop, but dealing with dust on my fluorescents, one thing to consider is that if dust is settling on the halogen bulb, it can act as an insulator. The bulb may be overheating and prematurely fail.

Re: Halogen Lights

#4

Re: Halogen Lights

John K Jordan

>For halogen around my lathe, I prefer the small sealed beam bulbs with the standard bases for bright task lighting.

JKJ

Re: Halogen Lights

#5

Re: Halogen Lights

Claudia Hayward

>I use the same light at my lathe and although it gets hot I've never had the problem you describe. I suspect you've got a faulty lamp. The only time I had a bulb fail prematurely was when the lamp fell over onto the concrete floor :) The heat is a good thing in the winter in an unheated shop!

Re: Halogen Lights

#6

JL

Re: Halogen Lights

JL

>Your lamp may be defective. I have several sets of halogen stand lights. I've had them all on for many hours over several years. I've replaced a single bulb.

Re: Halogen Lights

#7

Re: Halogen Lights

Fred Davis

>Larry,

Halogen lamp stands like the one 250 Watt one I have generate a lot of heat , much more then incandescent lamps.

Installation of Halogen task lighting burned down many homes and commercial buildings before they started regulating location of these and what you could do with them.

I used them for outside lighting on the barn and arena and garages until I got tired of replacing the entire fixture because of the heat generated damage to the lamp ends caused by the hot ceramic holders.

FredD

I switched to high pressure Sodium fixtures and most of the heat problems went away.

I also have much longer life with the old style incandescent flood lamps then anything else for outside lighting.

Re: Halogen Lights

#8

Jason Roehl in Lafayette, IN

Re: Halogen Lights *LINK*

Jason Roehl in Lafayette, IN

>Fred,

If you do a little research, you'll find that halogens are MORE efficient than incandescents, and actually produce less heat per watt, but are typically higher wattage.

I've found that for halogen work lights 300W lamps last much, much longer than their 500W counterparts, without a noticeable sacrifice in amount of light, depending on what you're doing, of course.

Jason


Light Bulbs

Re: Halogen Lights

#9

Dale Lenz

Re: Halogen Lights

Dale Lenz

>Larry,

I've got the same set up as yours, or so it sounds. Mines somewhere around 13 years old. The last element I replaces had the same problem as your, end crumbled, first time I seen that happen. Replaced the element and got on to work, maybe theres been a batch of inferior elements out there(?).

Re: Halogen Lights

#10

Re: Halogen Lights

Larry in NW Ohio

>Thanks It thing Bill hit it right on, since they are Sears with Harbor fright bulbs in them, what can you say for $1.00 bulbs. I`ll try and get a better bulb next time. Where do you get yours. Larry in Ohio

Re: Halogen Lights

#11

Re: Halogen Lights

Fred Davis

>I never said Halogen lamps were less efficient then incandescent or that they didn't put out more measurable light, but out here in John Deer country they don't last nearly as long outside.

In the capacity of a general contractor having Halogen installed on a nearly weekly basis , starting in 1988 when they were a new hot deal (in more ways then one ) in residential task lighting I rapidly got up to speed on installation issues with them.

As they became more common, the heat problem with house fires started cropping up and everybody , such as Contractors , Building departments , lighting engineers, especially Electricians were made aware on nearly a daily basis of the down side due to excessive heat, being installed under wood cellulose insulation and so on.

So I feel relatively comfortable in commenting on the plus and minus issues of Halogen lamps as a genre.

FredD

Re: Halogen Lights

#12

Jason Roehl in Lafayette, IN

Re: Halogen Lights

Jason Roehl in Lafayette, IN

>Fair enough.

My experience with halogens has been overall a positive one. I typically have a floor-style contractor halogen around (the ones low to the floor that cost $10-20), and I found that the 500W bulbs would only last me a few weeks. The 300W bulbs would last for years. The only reason they're hotter, though, is because they are typically higher wattage. How many incandescents do you see over 150W? How many halogens do you see under 150W? I once had a halogen bulb (I think it was 150W, standard threaded base) in a desk lamp that had a thick glass enclosure. I could hold the bulb after it had been on for hours. I haven't been able to find them recently, which is too bad, because it was great task lighting--paperwork or minor surgery (you know, slivers and the like).

Either way, the filaments themselves, when lit, register in the thousands of Fahrenheit degrees for either type.

Jason

Re: Halogen Lights

#13

Re: Halogen Lights

Fred Davis

>When I bought a halogen floor stand for the shop , it came either with 500 or 250 watt fixtures.

Since then I have seen many advertised at the same two wattage's, I haven't seen a 300 watt yet , but anything is possible.

One other aggravation with halogens are the two that I put into the top of a China Hutch I made for Dearly Beloved and damn if one didn't go out about a year later . T

They run on low voltage supplied by a step down transformer and I replaced the lamp in the one that was out , turns out it probably is the fixture, which is inserted from the cabinet top down and the cabinet top is about eight inches from the ceiling, .............so I am looking for a midget electrician.

Never get my hands into that space.

FredD