Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Grizzly 17" Bandsaw

Posts

Grizzly 17" Bandsaw

#1

Grizzly 17" Bandsaw

Pat O'Connor

>I just ordered the Grizzly G0513X Bandsaw and was wondering if the optional ceramic guides are worth it. I have the Carter guides on my 14" Delta and have not been impressed. Two bearings have failed and I find that the barrel adjustments are hard to make, especially on the lower blocks. Does anyone have the ceramic guides and opinions on them, if so, will be greatly appreciated? Thanks for reading and double that for anyone who responds.

Pat

Re: Grizzly 17" Bandsaw

#2

I have them

Dustmaker Mike

>and I like the ceramic guides. I have also seen just a few piece of hard wood cut to the proper size and used as guides. They seem to run cooler then the stock guides. I have never tried the carter bearings so I can not say if these are better then them.

Re: Grizzly 17" Bandsaw

#3

I Use White Oak

George@Colonel's Workshop-Havertown PA

>

Re: Grizzly 17" Bandsaw

#4

Re: I Use White Oak

Fred Davis

>George,

if you like making your own blade guides, get a piece of Lignum Vitae, that is what resaw machines use on a much larger scale but still the same idea,l very hard and self lubricating.

FredD

Re: Grizzly 17" Bandsaw

#5

Re: I Use White Oak

Larry in NW Ohio

>Fred Where can you get this Ligmun Vitae? Larry in Ohio

Re: Grizzly 17" Bandsaw

#6

Re: Lignum Vitae

Glenn Madsen near San Francisco

>There are modest sized pieces at my local Woodcraft for such purposes. May be some at the local Rockler, but I haven't looked. A pen blank should provide enough for two bandsaws for some time...

Re: Grizzly 17" Bandsaw

#7

Re: I Use White Oak

Fred Davis

>Larry,

email me your address and if I can find my remaining board of Lignum Vitae , I will send you enough to last a life time for blade guides.

FredD

Re: Grizzly 17" Bandsaw

#8

Good Stuff

George@Colonel's Workshop-Havertown PA

>Good Afternoon Fred,

I'll try some of that lignam vitae when my white oak runs out. Its been in the guides for six years or so already, and I transferred it from my old saw which I sold to my #3 son. When ever the oak gets a little worn, I put it against the disc sander to true it up again, then re-install. I start out with a blank about 2 inches long. White oak works well, and doesn't wear out too quickly..

George