Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Good Hope Hardwoods - Walnut Slabs & Specialty Hardwood Lumber

Dealing with gum in Douglas Fir

Posts

Dealing with gum in Douglas Fir

#1

Dealing with gum in Douglas Fir

Rob Scrimgeour

>I am making framed cabinet doors in Douglas Fir, and have one plank with very nice figure, but a section of it has small knots exuding gum. What is the best way of getting rid of the gum so that it won't give problems later?

Thanks for any input

Re: Dealing with gum in Douglas Fir

#2

Re: Dealing with gum in Douglas Fir

Robin Corell in Atascadero CA

>It is not kust the knots in doug fir tht will exude sap, it will also come out of clear VG boards. The diference is that in clear boards it comes out as tiny little droplets that harden quickly and can then be brushed off with you hand. what you are refering to is a bit more problematic and is best removed with a sharp blade. then go over the area with some dewaxed shellac and finish as you normaly would. it may continue to seep with rises in temp until it hardens which can be a few months to a year depending on the size. After the piece is finished and it seeps I wait until the drip hardens a bit and then carfully remove it with a razor blade. A good coat of paste wax applied prior to the seeping helps it come off the finish cleanly.

once the resins all oxidize and harden you will not have any problems with sap weeping out of the knots or any other area.

Robin

Robin

Re: Dealing with gum in Douglas Fir

#3

Re: Dealing with gum in Douglas Fir

Fred Davis

>Your sticky Doug Fir is caused by a careless or incompetent Kiln operator who did not raise the Kiln temp and keep it there for a while to "set the pitch" as the operation is called.

What that does is cause all of the sap that will run at that temp to run and leave the wood and normal temps after that will not affect the remaining resin.

This is a problem most often seen in green construction lumber.

FredD