>Does anyone have any experience with Lee Valley's table saw blades? My old WW2 is beat, and I never liked it anyway; burned too much. My old Systematic 50 tooth is easy feeding, but never cut very smoothly.
I use a plywood blade for ply, and a dedicated rip for thick rips, and I don't do much cross cutting. I'm looking at the Ridge and the Freud Fusion as well.
>Oh Wes, the sacrilege, you don't like a Forest blade. :-))
I don't know anything about the LV blades, in general LV doesn't sell any bad tools.
Personally, I am in the process of boxing and shipping 2 Woodworker II, and 1 chopmaster back for resharpening at Forest. When I started to cut the stock for my workbench, I could not get through a cut without burn marks on the maple. I swapped in a resharpened WW II, and the burn marks disappeared, and the blade cuts hard maple like it was butter. A resharpening will cost you in the neighborhood of $26 plus shipping. If you have never used their service, give it a try at least one time. My experience says that you will like the results.
Don't forget to check your fence for being parallel to the blade.
>I have Ridge blades for my table and RAS, also a Woodworker for the table. The Ridge stays on the RAS and produces a fine crosscut. They're all OK. For ripping I prefer a Freud rip blade; it makes glueline rips in 1 1/2 stock, feeds fast, and is inexpensive. For fine cutting, I use a Cermet tipped blade in the table. It was a custom order from Carbide Processors, Inc.
>Is there a local sharpening shop? One that does work for the professional shops in the area?
I've got one here, and I take my blades there for sharpening. I talk with the folk, and buy blades there as well. Never gotten a bad steer from them at all. They've been doing this for close to 40 years. Their 'house brand' blade is from FS Tools. Good stuff. Good price.
>Well, OK, but Bay Area Carbide is in Concord, about 6 miles away. Turlock is about a 90 minute drive, if the traffic doesn't clog in any of the seven or eight possible clog spots on the 4 Interstate highways it takes to get there... ;-)
I get to the sharpening service about once a year. I take almost all of my blades, and have them sharpen them up. There are maybe 7 or 8 of them, and that usually does it, unless my son has been abusing them again on one of his projects or another.
I used Bay area Carbide as a sharpening sevice and I remember when the old man started stocking FS blades from Germany. He was also a Systematic dealer, but he got a better dealer deal from FS.
They also had some good deals on overstocked router bits.
You don't need to drive to Turlock for Nordic, I never did, ordered over the phone and got them in the mail and I lived in Brentwood. FredD