Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

I'm baffled, table saw cut problem.

Posts

Re: I'm baffled, table saw cut problem.

#26

A clarification please

jeff

>I get the idea of adding a shim.

And from reading, I need to add it to the front.

But, does it go between the top and where it bolts or does it need to go inside near (or on) a trunnion (as was said in an article.)

As you can tell, I've never had to take a cabinet saw apart in all these years.

Jeff

Re: I'm baffled, table saw cut problem.

#27

I'm back to step one

jeff

>Hi all

No time today to do much.

It was suggested that I slow down and do a real slow cut.

So, I did that.

I checked the cut and it was concave, or where I started with again.

But, the amount is very small, not even a playing card's worth.

But for the fine boxes I'm building, this is still a problem.

Do I go right to shimming or is there another way to get around this?

Jeff

Re: I'm baffled, table saw cut problem.

#28

Re: A clarification please

Glenn Madsen in the SF Bay Area

>It's a wedge, essentially. Put it where the geometry works, and where you can get to it. The process is trial and error.

Have fun with it.