Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Honing stones

Posts

Honing stones

#1

Honing stones

Larry in NW Ohio

>I have a few honing stones that are a few years old and are dirty.What is the best way, if any, to clean them. They seem like they are plugged of filed up with dirt. Can this be? I tried to blow them out with the air compressor, and didnt seem to do anything. Can they be cleaned? Thank You Larry in Ohio

Re: Honing stones

#2

Re: Honing stones

Jim Hoeller

>I've had some success with soaking the stones in kerosene. It seems to loosen the filings that clog the stones. After a day or so, a stiff bristle brush gets the stone clean.

Re: Honing stones

#3

Re: Honing stones

Bob Persing

>Larry,

It depends upon what kind of honing stones you are talking about. If they are "water stones" I would just go through the procedure to re-flatten them, this would clean up the surface. If they are Arkansas type stones I have success with washing/scrubbing mine using toothpaste and rinsing then drying thoroughly. Same treatment for ceramic stones. If they are the porous carborundum type stones I have had some success using Simple Green to wash them but I would not soak them in Simple Green as I'm afraid this might destroy whatever is used as a binder.

There is no scientific backing for my approach, just seems to work for me and I don't think I have destroyed any of my honing stones yet.

BTW-if you were talking about the diamond "stones" from folks like DMT, I have cleaned these by washing and scrubing with scouring powder and a fingernail brush.

Good luck on your recovery cleaning.

BobP

Re: Honing stones

#4

Re: Honing stones

Bill Tindall, E.TN

>Let me guess that the real issue is that they don't cut as fast as you would like and the thought is that the grits may be plugged up with junk so that the abrasive is not sufficiently exposed, right?

Carrying this assumption forward, indeed the stone may be gunked up with metal particles, or you may be trying to hone one of the more abrasion resistant modern steels that don't abrade very quickly on oil stones.

The problem, in my mind, with old fashion stones is that they don't wear fast enough to expose new sharp edged abrasive particles. The water stones solve this problem by binding the abrasive with weak clay or something so that the worn grit falls off and new sharp particles are continuously exposed.

Ask how to clean the stones on the hand tool forum. There are many over there that used them. I would be inclined to rub them on a diamond stone or some coarse silicon carbide such that a new abrasive surface was exposed, but this is a guess. Any solvent will remove oil. It will take something mechanical to remove metal, or a soak in hydrochloric acid.

Re: Honing stones

#5

Re: Honing stones

Larry Clinton At Frankfort (Central)., Indiana

>I am assuming you are talking about oil stones - not water stones. If you have used a honing oil with them as you used them as I do, they should be pretty easy to clean. Mine come clean very easy by putting honing oil on the surface and rubbing with my finger tip to pick up the old oil and contaminates, then I wipe them clean with a rag. I always pre-coat my oil stones with honing oil - 3 in 1 oil or mineral oil with a little lamp oil makes decent honing oil - or any real light oil I have on hand mixed with lamp oil. This makes any particles easy to remove after use.