Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Shop acs and Swimming Pools (OT)

Posts

Shop acs and Swimming Pools (OT)

#1

Shop acs and Swimming Pools (OT)

Dustmaker Mike

>Yup I am going to use my shop vac in a swimming pool. The cover is so full of water the ball (ballon) under has sunk. I have a 16 gallon shop vac that is both wet and dry. The question I have is when I pull the plug out of the bottom of the tank it will not suck water. I put it back on and it sucks the water out really fast. I just have to keep stopping to empty it. I want to use the shop vac as a pump to suck the water out but I can not find a hose big enough to put on the threads that hold the plug on the bottom. Am I waisting my time because the Shop Vac will not work this way? I was going tomorrow to find an adaptor too put the hose on if it will work this way. Will this work this way? My shop don't have any sawdust in it anymore it is really clean that is a plus(-;

Re: Shop acs and Swimming Pools (OT)

#2

Shop Vacs

Dustmaker Mike

>

Re: Shop acs and Swimming Pools (OT)

#3

Re: Shop acs and Swimming Pools (OT)

Bartee

>I think you will have to have the water level in the vac above the open outlet. If not you are sucking air in thru the water outlet.

Re: Shop acs and Swimming Pools (OT)

#4

Re: Shop acs and Swimming Pools (OT)

Al Stokka - Cambridge, Iowa

>A shop vac depends on a closed container to develop suction. Air (or water) will enter via the path of least resistance. If you must use the shop vac, you'll have to settle for sucking up water one container at a time.

Al

Re: Shop acs and Swimming Pools (OT)

#5

Remove the tank......

Mark Goodall - ATL - tooljunkie

>

Re: Shop acs and Swimming Pools (OT)

#6

Re: Shop acs and Swimming Pools (OT)

John K Jordan

>I would not attempt to use a shop vac for this application.

When I had a swimming pool I used a small submersible pump for to remove excess water. Connect a standard water hose to the fitting, drop the pump and hose into the pool, and plug in the pump. The pump was about $30 from a swimming pool supply shop, but I used it for perhaps 10 years until I moved. It was fairly slow to remove a lot of water, but it's very quiet and can run for hours as needed. The pump I used had a plastic grating at the bottom to avoid sucking leaves and junk into the impeller. I used the pump every week or so throughout the winter. I liked to keep only enough water on the cover to avoid problems from the wind.

JKJ

Re: Shop acs and Swimming Pools (OT)

#7

Re: Shop acs and Swimming Pools (OT)

Larry in NW Ohio

>Mike If you happen to have a Sears Vac I think you can buy an accessory called a pump out. Now I don`t know much about this and it doesn`t say much in the catalog but I think that you attach this to the drain opening and use it to pump the water out. Hope this helps. Larry in Ohio

Re: Shop acs and Swimming Pools (OT)

#8

Thanks All

Dustmaker Mike

>A 5 gallon bucket and a 16 gallon Shop Vac (empty every few minutes) did the trick. This is at a neighbors house whos husband is outa town. He gets home today sometime. This is one less job he will have to do. It is a sears shop vac so I will look into the pump out thing. I wonder why I don't have a pool, I think they are to much work and this is just one more reason I can tell the LOML when she says shes wants a pool.

Again Thanks