Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

D4R users; Have you cut sliding dovetails?

Posts

D4R users; Have you cut sliding dovetails?

#1

D4R users; Have you cut sliding dovetails?

marc rosen

>Hey Group,

I'm looking for feedback from D4R users on routing sliding dovetails. I'm getting ready to make a three shelf unit (all 7/8 inch oak)that is 48 inches tall. The shelves are 44 inches long. Cutting the tails in the shelves looks easy and this is where I think the jig will be perfect, but I'm concerned that I might not get the best results gutting the slots.

I'm not being critical of the jig- it's my own skill that concerns me. I think I'll do a better job if I use a separate guide rail and lean on a table or the floor.

Any comments and suggestions are welcome. Thanks in advance,

Marc (just ignore the Woodduck)


img

Re: D4R users; Have you cut sliding dovetails?

#2

Re: D4R users; Have you cut sliding dovetails?

David

>Marc,

I have a D4 and find that while I love it for most dovetails, I'm not crazy about it for sliders. I wouldn't be surprised if it's a skill level thing and not the fault of the jig, but for now I prefer to use the table saw and router with a straight edge or just the router/st.edge depending on the application.

Hope this helps but you should probably hear from the more experienced folks too.

Re: D4R users; Have you cut sliding dovetails?

#3

Re: D4R users; Have you cut sliding dovetails?

marc rosen

>Hello David,

Thanks for the reply. I think my approach will be to use the table saw to score a 1/4 inch deep groove, followed by the router and straight bit, and then follow with the router and the dovetail bit. I do plan to use the Leigh to cut the tails in the shelf ends though- I can see where this portion of the process would not have as much chance for the bit to wander and if it does slightly I think any error could be hidden by the shelf edge anyway.

Thanks again,

Marc