Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Combination Press Plough Plane

Tablesaw fine adjustment - help, please.

Posts

Tablesaw fine adjustment - help, please.

#1

Tablesaw fine adjustment - help, please.

Robert R Clough - Thorncraft

>I cannot remember what the device is called that one may add to a table saw fence for fine adjustment. I remember seeing it "recently" in a catalogue. I looked, at least cursorily, in Rockler, Hartville, Highland Hdw, and Lee Valley. All I remember is that it was an add on.

Does anyone here remember this?

Re: Tablesaw fine adjustment - help, please.

#2

Re: Tablesaw fine adjustment - help, please.

Larry in NW Ohio

>If this is what your looking for, it`s in Rockler on page 143 in the Febuary 2008 catalog. It`s called Table saw Magnetic Micro Adjuster. If you get one, let us know how it works. Larry in Ohio

Re: Tablesaw fine adjustment - help, please.

#3

un-needed

Bill Tindall, E.TN

>I have a Delta saw with the vintage fence, which is to say I use the least sophisticated fence on this forum. I have never encountered a situation where I could not adjust it to the precision needed for the work I do. What are you wanting to do that any old fence won't accomplish?

Re: Tablesaw fine adjustment - help, please.

#4

Re: un-needed

John Pappas

>hmmm, the least sophisticated fence. I think I may have the same (or similar) fence. So, it's a tie... Hope you don't mind sharing the top spot..

Re: Tablesaw fine adjustment - help, please.

#5

Re: un-needed

Robert R Clough - Thorncraft

>Well Bill, my old Delta fence, the original one, had a micro adjuster which worked very well. I bought a new T2 fence because I could no longer keep the old fence parallel. I wish to at least look at a way to micro adjust my new fence - hitting it with my hand (micro) or finger (micro-micro) just doesn't quite cut it.

Re: Tablesaw fine adjustment - help, please.

#6

Re: un-needed

John in Calgary

>Ok, I think my old craftsman fence might take the least sophisticated prize, but lets not argue that point right now.

For fine adjustment, I have always used two hands. Grab the edge of the table on either side of the fence slide, both thumbs pointing towards the fence. Use one thumb to push, the other to resist the pushing motion, you can get some amazing fine control this way. (if you can't quite picture this, take both hands and pretend you are a movie director trying to frame a scene with your hands, thumbs together, now place the fence between your thumbs and use the table as your leverage)

Now if your question is more related to actually measuring the fine adjustment, that is a different story - my skill level has not required the ability to adjust consistently with this 'accuracy' yet.

John

Re: Tablesaw fine adjustment - help, please.

#7

Re: un-needed

Chet Bisno

>Start with the following: JB Weld, a dial indicator magnetic base (cheap at Harbor Freight), a large threaded rod connector, a bolt that fits the connector, Liquid Wrench and a permanent marker.

Use the JB Weld to fix the connector to the magnetic base so it's parallel to the table at a height you like. You might also want to smooth off the bolt head. Insert the bolt into the connector with just a miniscule drop of Liquid Wrench to avoid a sloppy fit. Be sure to leave enough of the bolt protruding to get a good turning grip. Find the center of resistance on your saw fence and mark it with the permanent marker. You can then position the magnet so the bolt pushes on the center of resistance for micrometer adjustments. If you have difficulty moving the fence with the bolt, wrap it with tape for a better grip.

Unfortunately this only works on the push, so I always start about a quarter of an inch beyond my point to the right of the blade and push back to it.