Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

Contractors table saw dust collection

Posts

Re: Contractors table saw dust collection

#26

Another Option for Contractor's Saw Dust Collectio

Robby Wright

>I learn how to spell next week.....

Robby W.

Re: Contractors table saw dust collection

#27

Re: Another Option for Contractor's Saw Dust Colle

Robert R Clough - Thorncraft

>I thought you were talking about Pharoah Anotehr of the 5th Dynasty. ;)

Re: Contractors table saw dust collection

#28

Re: Another Option for Contractor's Saw Dust Colle

Chuck Lenz

>Robby pretty much hit the nail on the head, except my dust chute is made from sheet metal. I'm thinking of puting a large speaker magnet on the outside, so if I do drop the arbor nut or flange washer, it won't go any farther.

Re: Contractors table saw dust collection

#29

Re: Another Option for Contractors Saw Dust Collec

Barry Irby

>I went to Rockler, but could not find the Big Mouth fitting.

I think the principle here is that the saw tends to throw the saw dust straight down or down and to the rear. The collector should be aligned with this flow and catch it as a natural extension of that path.

The hopper or catcher should be smoothed out or feared so that there are as few as possible places for dust to accumulate, but OTOH, if the build up of dust does not interfere with operating the saw, its harmless to your health. The system tends to be "self fairing". corners fill in to a certain level and then no more dust can sit there and the rest falls into the chute.

I tried to find those long brushes they use on big truck trailers to shield around the tires. The sort of hula skirt looking brushes. Seemed to be a good thing to close off the back of the saw with. Would permit air flow inward bout would restraint the larger particles from escaping.

The idea of huge air flow inward is good. It may be that the larger particles have the energy to escape the air flow, but I believe the smaller ones will expend there energy and be sucked back into the chute. It's the very small ones you really want to take out of the air. My DC is outside the shop in a small shed or closet and once the fines are in the chute, they either end up in the bag or exhausted out doors.

Re: Contractors table saw dust collection

#30

Re: Another Option for Contractors Saw Dust Collec

Chuck Lenz

>I think the fitting you are looking for is call The Big Gulp. Amazon has them. While it is close to what I have, there are two differences, mine is heavy gauge sheet metal and doesn't need a elbow at the bottom. Elbows are something that should be avoided, especially tight radius elbows.

Re: Contractors table saw dust collection

#31

Re: Another Option for Contractors Saw Dust Collec

Carol - now in NC Nebraska

>"sort of hula skirt looking brushes"

Look for door sweep brushes. Not as thick but work very well. Also relatively inexpensive.

Re: Contractors table saw dust collection

#32

Re: Another Option for Contractors Saw Dust Collec

Barry Irby

>Carol, What I was looking for have bristles about 6 or 8" long. I see them on road trailers to knock down the spray off the tires.

I got some that have bristles about two inches long. I used them on the under side of my table saw insert and they hep to direct the dust into the chute.

Re: Contractors table saw dust collection

#33

Re: Contractors table saw dust collection

Chuck Lenz

>ShopShots #818 in this website was the first one I made. I have since then changed the design twice, streamlineing it. Your obviously free to make and use the one in ShopShots. I think you will find that it still works much better than the generic plastic ones that come with some Contractors table saws, I know it did for me.