>When SWMBO purchased the chest freezer they delivered it and discovered a scratch on the back at the very bottom. I didn't even see it when they were bringing it in and probably never would have. The two dudes look horrified and called it in insisting that the bill be amended to take %25 off the ticket. They did too ! 10 years and NEVER a problem.
>I bought mine at the local Sears Outlet. They had 3 of them sitting there that were all identical except for various damage. I looking at them, I realized that if you switched parts around, you could make one good one out of the three. I asked if they cared, sure that they would say NO! The guy said "I don't give a d@*$ what you do!" So I got my tools out and rearranged the parts and got the machine for about half price, with a full warranty. Can't imagine they would let that happen again.
Be careful at Sears. They mark them down about ten percent at a time, over and over until they sell. So when a truck load comes in they all get marked down about ten or twenty percent. You can get that much discount at the store without buying a damaged one. Week by week they go down. So, at first there are machines sitting there that look perfect next to ones that look like they fell off the truck on the interstate, all at the same price. Gradually they start to sell when the price Vs. damage meet up.
>Save your money and buy a top loader. I bought top of the line Frigidaire and it cost me two service calls and then two DIY's for a total of a good top loader. Tossed that damn front loader when the primary bearing went south and the cost to fix was 70% of a top loader.