Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Abingdon, VA – Tree Cutting & Portable Sawmill

storing dried lumber

Posts

storing dried lumber

#1

storing dried lumber

michael kula

>I have read back over a lot of the posts on here about drying and storing lumber, but haven't found specifics to help me with my first question.

#1 I have several hundered board feet of 4/4 kiln dried lumber (dried in summer 05) that is currently stacked and piled in a pallet shape, all still with stickers between layers in my basement. My shop is small, and since I see dried lumber stood on end in retail lumber yards, I am wondering if that is fine for me to do to save floor space? In other words, can I stand it up, lean it against wall without worrying about maintaining flatness? The only stuff I can find about this type storage is that if I do it, to make sure the ends of the board would not be making contact with floor, concrete, to prefent them pulling moisture in at that end. Any advice/warnings about doing this? It sure would save space for me. For basement configuration reasons, the horizontal wall storage systems I have seen, wont work for me. Oh, if it matters, the boards are walnut, maple, hickory and run anywhere from 4 to 12" wide by 6-10 feet in length.

On a related note-- I also have about ten boards of 8/4 lumber from the same trees that were never kiln dried. They were supposed to sit out and air dry for a while before we sent them in, but my wife and I had a baby in the meantime, and well, you know the rest. Just wondering about dryness for them at this point to use them? 2 and 1/2 years air drying? The last year or so in the basement? Thanks in advance for help on both/etiher these questions

Re: storing dried lumber

#2

advice

Bill Tindall, E.TN

>1. If air can freely get to it, the 4/4 and 8/4 lumber is all the same moisture content by now.

2. I don't know why your lumber is still on sticks.

3. Once dry, lumber is not going to warp or twist in the absence of external forces. So how ever you stack it, it will stay the same shape so long as your stacks don't stress the pieces and deform their shape. To that end, don't lean a stack against the wall at 45 degree angle or make a horizontal pile with support only at each end.

When commercial lumber comes out of the kiln it gets dead packed, and at least in my region stacked in outdoor sheds awaiting sale, see PIC showing a typical arrangement.


img

Re: storing dried lumber

#3

So....

Randy Johnson Connersville IN

>I have over a pickup load of ash, cherry, and walnut that was given to me. It was cut into boards 25-30 years ago. The shop was under construction when I got it and it is currently stored elsewhere, mainly because I have yet to come up with an idea for a lumber rack that will be practicle without taking up too much room.

Getting it all to the shop is one of this summer's come hell or high water projects.

It has always been on sticks. Am I going to be ok stacking four or five deep without sticks as long as there is support every 24 inches"? If so, you just saved me a lot of money on the cost of my lumber rack.

Re: storing dried lumber

#4

Re: So....

John Veerkamp

>No problem. it is as stable as it'll ever be. @4 oc is good support.

John

Re: storing dried lumber

#5

Re: storing dried lumber

DizD

>For more information than you would ever want, USDA Forest Service Agriculture Handbook 531, Storage of Lumber, available on Forest Products Lab website.

Re: storing dried lumber

#6

A system for storing dried lumber

Robin Corell in Atascadero Ca

>One of the best solutions for lumber storage I have had the pleasure to work with was where I did my apprenticeship. It was a vertical system with the heart of the system being a horizontal 2x4 attached to the wall about 6' above the floor. The 2x4 had holes drilled every 6" and sized for an 18" length of black pipe. The holes were at a slight angle but only enough to keep the pipe from falling out. The wood was then stored standing on the floor and leaning slightly on the pipe and several pieces would be stacked on top of each other sand supported by a single pipe. It kind of resembled a huge bookcase in the way it functioned. you could then tip the top board over to the opposite pipe and sort through to the board you wanted, kind of like browsing for a book on a shelf or if you are old enough an LP. The height of the pipes worked fine for shorter boards as long as there was a tall board placed against the pipe. With the boards standing nearly vertical the difference in length of adjacent boards is not the problem it is when storing them horizontal. Another reason I liked this system is that the boards can be stored closer to vertical than if you stack them against the wall because you don't have to worry about them falling away from the wall and into the workspace. And it can also be sized to take up less floor space. The beauty of this system if you haven�t figured it out is that there is no bottom to the pile.

Robin

Re: storing dried lumber

#7

support spacing

Bill Tindall, E.TN

>When we sold lumber our racks had support every 4 feet. I am sad to say that some lumber stayed on these racks for many years before it got sold and there was no sign of sagging in between supports. KD lumber is very stiff, unlike green lumber.

Our racks had supports at 0, 4, 8, and 12' with 2 additional feet from last support to the outside wall. Two layers of 12' lumber always formed the bottom layer. After that I was not concerned with putting 10, 14 or 16 ' or any other length of lumber in the rack. I never saw any evidence of sagging.

Re: storing dried lumber

#8

The disadvantage is that you need a 12' ceiling

Bill Tindall, E.TN

>The best compromise of ease of handling and minimize waste is 12' lumber. It is also the easiest sized pack to buy. I really like the idea but it seems impractical for a home shop with typical ceiling ht.

Re: storing dried lumber

#9

Re: The disadvantage is that you need a 12' ceilin *LINK*

Alan in Little Washington (NC)

>I think vertical is the way to go- easier to stack, unstack, and view each piece. See the link about my rack.


img

Link to my rack

Re: storing dried lumber

#10

That is the way I stored my wood. Saved hours of

henthorn

>time wasted in stacking and unstacking wood to find the piece I wanted.