Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Help with old Delta lathe

Posts

Help with old Delta lathe

#1

Help with old Delta lathe

VLParisian

>Today I acquired an old Delta lathe ( catalogue # 46-612P Ser # 93010505) It is missing the tool rest. Any thoughts on where I might purchase a replacement? Anybody know anything about this model? All I know is that the previous owner bought it at a school auction some years ago and never used it.

Victor - in cold and wet Houston

Re: Help with old Delta lathe

#2

Re: Help with old Delta lathe

Robin Corell in Atascadero Ca

>I'm pretty sure most of the delta lathes and all of the 46 series all use the same tool rest. I broke one years ago and they had them in stock at a local delta dealer. It was a newer style but worked fine. The also pop up on ebay regularly and ocasionaly go for enough below retail to pay for shipping.

Re: Help with old Delta lathe

#3

Tool rest or Banjo?

Phil Joines Krum, Tx

>Tool rests are available at a bunch of places. The banjo is a bit harder but they are available. If you can't find a Delta look at one for a Nova DVR or 3K from Woodcraft. I used one when I added riser blocks to LOML's Delta Industrial. Just needed to make a new clamp plate for it.

Re: Help with old Delta lathe

#4

Thanks guys. I knew I could count on the board

VLParisian

>

Re: Help with old Delta lathe

#5

Re: Help with old Delta lathe

Mike L, Orange County, CA

>You can get Delta tool rests and banjo from Amazon.com. You may have to dig around their site to find the banjo (at least I had to) but it's there. Good luck.

Mike