Re: Super chainsaw chain question?
Rob Stokes in North Vancouver
>It's carbide chain and it's pricey, typically at least twice the price of regular chain. Harder and more pricey to sharpen too.
But I'm curious why you think you need it? are you wearing out chains or do you want longer between sharpenings? If it was that much better or ore cost efficient, everyone would be using it but the choice of professionals is still good old regular chain.
For regular bowl cutting etc. a regular chain will last just fine. If you're cutting a crotch and it's got dirt etc. in it, take a second with a garden hose and wash it out. That will extend the life of the sharpening.
If you're not good with a file or don't want to sharpen your own chain, buy another loop of regular chain and have it handy. That way when the one on the saw is dull you can swap them and take the dull one back to the shop for some work. I do this with my milling chains except I have my own sharpener. But swapping instead of sharpening makes for more productivity out in the field.
Whenever you swap chains, flip the bar over to help even out the wear. And after you've flipped the bar so it's got two or three chains run on each edge, take it in to have it squared and the chain groove re-sized. It only takes the shop a minute to do and it makes a huge difference to being able to cut straight. This is even more important is you're cutting in grit a lot.
Lastly, look around for a vegetable based bar oil. Remember that every drop of oil you put in your oil tank ends up in the environment in it's raw form. If you're using a petroleum based oil, you're basically dumping 10w-30 (or equivalent)out on your lawn - not cool.
The veggy based oils used to be more expensive but are now much closer in price to regular bar oils. They've got added tactifiers in them to make them sticky and we've found their lubricity to exceed regular petroleum oils based on bar/chain temps and bar life. For me, there's no going back.
You use a bit more (it typically flows better than petroleum based oils so if your oiler settings remain the same you'll notice an increase in the volume you use. You can also turn down the oiler if this is an issue), but you don't have to worry about slinging it everywhere, or overfilling your tank, or bringing wood into the shop that has spillage on it.
You can purchase the oil in 1 gallon bottles, but if you're going to use a lot or if you have buddy's with their own saws, buy it in 5 gallon pails and decant it to field-sized bottles.
Good luck
Rob