Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A55 Smoothing Plane

Sanding belts

Posts

Sanding belts

#1

Sanding belts

Larry in NW Ohio

>I`m in need of some 4X24 sanding belts for the Ridgid sander, which is so far pretty nice. I am looking at the "Famous box of belts" in Klingspor catalog. Has anyone use these? They say that they are "Industrial" belts, does this really make them better? Anyone have any experience with them? TIA Larry in Ohio

Re: Sanding belts

#2

Re: Sanding belts

George@Colonel's Workshop

>Good Afternoon Larry,

I buy belts from Klingspor and have been very satisfied with them.

George

Re: Sanding belts

#3

When a bargain is not a bargain.

Basil

>Several years ago (long time) I bought a "BUNCH" of Klingspor sanding belts at a bargain. I mean they were dirt cheap and I loaded up. Well, the first few years they worked just fine but as time went by, they begain to fail (glue joint)faster and faster with use. The other day I went through 4 or 5 in a few minutes.

Moral of the story, cheap ain't always the cheapest way to go. If you get a bargain be careful that you don't over do it.

This is not meant as a rant against Klingspor sanding belts. ....just a warning for fellow tightwads....LOL

Basil

Re: Sanding belts

#4

Re: When a bargain is not a bargain.

Scott Crumpton

>This is somewhat normal for sanding belts. I've read that the adhesive has a limited lifetime. I've made mine last longer by keeping unused ones in ziploc bags, in a drawer out of the light (UV) and heat. So far, so good, but only time will tell. BTW, I've been quite satisfied with their products and only buy other belts in an emergency.

---Scott.

Re: Sanding belts

#5

Re: When a bargain is not a bargain.

JohnKJordan in East TN

>I've heard that humidity is a primary destroyer of abrasive adhesive and welding rods.

JKJ

Re: Sanding belts

#6

I sent the belts that did that back to klingspor

henthorn

>and they replaced them without a whimper.

Re: Sanding belts

#7

Speaking of the Rigid sander

Jay Lombardo

>Speaking of the Rigid sander, does anyone else have trouble with the tracking on the belts? I like the spindle sanding part but I cannot get the belts to track properly, I have fiddled with it ENDLESSLY but still can't get it to track properly! Anyone have the same experience, and/or suggestions?

Thanks,

Jay

Re: Sanding belts

#8

Re: Speaking of the Rigid sander

Barry Irby

>Take this with a grain of salt and try it only if you are willing to undo it and not be upset. A friend had a belt sander that would not track. He put a piece of duct tape around the middle of the front roller. Then he ripped a piece in half long ways and put a narrow strip on top of and centered on the first strip. He ripped the other piece to a quarter and put that on the center of the second piece. This created a crown on the roller. It worked for him.

I am not familiar with your sander at all, so I am shooting from the lip, but wouldn't take much to give it a try.