Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Urban Salvaged Hardwood Slabs, Milled In-House from Rare Trees. Shop Unique Walnut Stock.

Need Help Choosing Miter Gauge

Posts

Re: Need Help Choosing Miter Gauge

#26

Incra 5000

John in Mid Mich

>I have the Incra Miter5000, which is a sled and miter gauge combo, kind of like the Dubby that some have described. However it includes the Incra repeatability benefits that come from having the indexed parts. In particular, the indexed flip-stop makes for dead-on accurate cuts without any need to measure. Of all my woodworking equipment purchases, this is probably the one that has had the most beneficial impact on my projects. I really think the accuracy and repeatability of the Incra stuff is worth the cost. I suspect I'd be almost as happy with any of the lower Incra models (3000, 1000, etc.) that are just gauges, but the combination with the sled makes for a real pleasant system.


img

Re: Need Help Choosing Miter Gauge

#27

Rockler has less expensive Dubby clone *LINK*

Alan in Little Washington (NC)

>Rockler is selling a Dubby clone for $119 (vs $179 for a Dubby). I don't know anything about it but it is decent looking and has a metal scale like the Dubby marked off in 1/2 degree increments.




Rockler's Dubby clone

Re: Need Help Choosing Miter Gauge

#28

Re: JessEm Mite-R-Excel

M. McNamee

>Yes. I will review to the best of my knowledge how the three gauges 'tighten up' in the miter slot.

The Rockler guage uses a thinner second bar that rides below the main bar. There are 3-4 hex head screws that are used to keep this second bar in place. Might not work well with a T slot.

The Incra uses circular plastic disks. There is an eccentric mounting system that is used to rotate each disk to take up the gap between the bar and the slot. One is hidden under the gauge body so it has to be disassembled to adjust. Worked well but I did not like the flexibility of the main body.

The JessEm used three brass strips in the side of the bar body. A hex head screw in the top of the bar performs the adjustment. It might be an eccentric type of setup that pushed the brass strip outward.

That help?