Re: A photo-essay response. Response------WebKitFo
Sgian Dubh
>Keith, there was no intention to 'slap you down' through posting the photo essay elsewhere. That was intended merely as information for others to read and perhaps help them decide how they might tackle veneering jobs. I aplogise if I insulted you: it was unintentional.
60�C isn't quite as hot as you converted to. It's closer to about 140�F, but even at that I think the adhesive from either masking tape or drafting dots/tape is driven into the wood. But heat makes veneering so quick; with heat it takes less than 2 minutes to press both veneer faces to the ground simultaneously. For that experiment I used PVA, which I commonly use for veneering. The other glue I use quite often for the job is urea formaldehyde. I've never used epoxy resin for veneering. Without heat PVA needs about 30 minutes in the press at 20�c (~68�F), and the common powder plus water urea formaldehyde glues need 3-1/2 to 4 hours.
Therefore, for speed and large jobs, it's a bit of a no brainer to use heat. I can do five to six smallis pressings on my own in an hour, and with an organised team and fairly large panels you can easily double that amount of pressings, ie, both sides pressed simulataneously.
To remove the tape I gently peeled an edge with my fingernail and then pulled gently backwards parallel to the veneer face. I removed the tape while the panel was still hot as it's my experience that it causes much more damage if the panel, tape, and adhesive are all cold.
I usually remove paper veneer tape with a water damp cloth rubbed over the tape, wait a while and then peel it off. It works pretty well. I haven't very often sanded the tape off as it hasn't always worked too well for me.
I often use masking tape, or low tack tape to join veneer seams, but I use it on the underside in short strips across the seam spaced roughly 100- 150 mm apart. Then I turn the leaves over to the show side and tape that with veneer tape and water, and usually roll it down. When that's dried thoroughly I turn over again and take off the initial leaf assembling masking tape, then I glue the job up. I only assemble leaves of veneer I can glue up that day, or at most in the next 12- 24 hours or so; long term adhesion of the masking tape isn't a problem usually when used like that. The masking tape does seem to help stabilise the veneers as the veneer tape and moisture does its stuff trying to distort the assembled leaves.
So, again I apologise if you were insulted by posting my photo-essay thing in more than one place as that definitely wasn't my intention. Slainte.



