Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Sharpening question?

Posts

Re: Sharpening question?

#26

Sharpening.honing

ron in kokomo

>I wish I could remember the details of Marc Adams's story about his desire to learn about tool sharpening/honing from one of the great masters of the craft, Tage Frid.. Long story short Frid used a belt sander and a buffing wheel. When Marc registered his disbelief Frid asked him if he wanted to work wood or sharpen chisels?

Now understand, Frid used very very sharp tools. But there are many ways to achieve that result. Periodically we go through this discussion over on the hand tools side and people get very emphatic about what is the best way to get there but there really can be no debate that sharp tools do better work, and getting your tools to their sharpest possible makes the work easier as well, even though their is some learning required to do it well.. whatever the method.

Re: Sharpening question?

#27

Re: Sharpening question?

Bill White

>Well, our predicessors did not have the ultra high tech stuff that we do, and the seemed to do ok.

I'm using the bench grinder, Makita horizontal stone jobby, and waterstones.

I can get 'em pretty darned sharp that way.

Now if you want to go to .00002 microns???? I'll leave that to others.

Bill

Re: Sharpening question?

#28

Fond an old timer who can show you how to

henthorn

>hand sharpen bits on a grinder. Takes a couple of minutes to learn the trick and it is faster than a blink. I was recently drilling balancing holes in the cast iron fins of a flywheel. I needed 1/4" holes. Started out with a 1/16" bit and even with my old eyes sharpened it so it went through the cast iron like butter. I then sequentially advanced up to the 1/4" bit, sharpening each bit as I used it. Was through almost before I began.(G)

Re: Sharpening question?

#29

should be FIND. Grrrrrrr

henthorn

>

Re: Sharpening question?

#30

The more you sharpen, the less you sharpen

wilbur

>The thing I've learned is that regardless of what method you use, the more you sharpen, the less you sharpen.

What that means is that it takes less time overall to spend a few minutes honing your tools each time before using them than to use them until they get dull, and then having to have a major sharpening session to get them useable again.

For the record, I use waterstones, and have tired Scary Sharp. I like waterstones better.

Re: Sharpening question?

#31

Re: Fond an old timer who can show you how to

MikeW

>Thanks. I know how to sharpen drill bits. Solid carbide are another animal altogether. For one, they really like diamonds, not spinning stones. For another they are extremely fragile, especially at the size I mentioned.

Still, I have freehand sharpened them on a bench grinder. Takes a bit more pressure than the light kiss HSS bits take. Break an $8-$12 bit and a DD is pretty darn cheap.

Take care, Mike

Re: Sharpening question?

#32

PM30 for shaping, Shapton for sharpening

Ross

>I do all of my grinding and flattening on my PM 30 belt/disk sander. The plates and plattens are flat and the fences can be set to any angle. I can't see getting a dedicated sandpaper plate grinder when I have this thing sitting here. I can get things close enough. I then move to Shapton 2000 grit, followed by 5000 and 8000. I may get one more down around 1000 for more aggressive shaping and cleanup.