Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Interesting consideration gluing a edging

Posts

Interesting consideration gluing a edging

#1

Interesting consideration gluing a edging

Link Van Cleave

>I need to glue a piece of Wenge on the edge of some 3/4 plyboo bamboo plywood to make a table top. The plyboo is 3 layers of bamboo alternating grain. Although bamboo is a grass I am assuming it behaves like wood as far as glue strength. The Wenge edging is 1 1/8" thick by 2" wide. When you look at the edge of the plyboo you have roughly 3@ 1/4 layers. So on the long edge you have side grain gluing on the two out side layers, maybe 1/2" decent glue surface total. Not a lot but at least being the 2 outside lams in good structural position. Plus a spline in the center will be cutting into end grain only so you would get more glue surface, alinement, and some mechanical strength. The dicey part as I see is at the ends of the table where a spline is out of the question as it will cut into your only side grain gluing, and you only have about 1/4" side grain glue surface and it is in the very center of the edge, not the best place for strength. The edge is 2" wide, a lot of leverage could be applied by someone leaning or sitting on the edge. In my glue consideration I am thinking of epoxy for the strength it would give me on the end grain surfaces. Mechanical as opposed to chemical bonding. I will do a test today. Yellow glue, poly glue, and epoxy with and without splines. I will post results.

Link

Re: Interesting consideration gluing a edging

#2

Re: Interesting consideration gluing a edging

Robin Corell in Atascadero Ca

>One option would be for you to cut a rabbit on the top and bottom of each end. this would create an tounge with side grain.

If it were me I would use hot hide glue, but I use it for everything.

Robin

Re: Interesting consideration gluing a edging

#3

Re: Interesting consideration gluing a edging

pecker

>Can you build up the thickness of the ply at each end, by gluing a scrap strip of it to the underside? Making the edge 1.5" thick?

Re: Interesting consideration gluing a edging

#4

Re: Interesting consideration gluing a edging

DB

>I would use pocket screws and glue to attache the wenge to the plywood. Then build up the perimeter about 6" inside the wenge with plywood or whatever scrap you have on hand. Make the buildup to the same thickness as the wenge. The buildup will make the edge stronger and give a better feel to the underside of the table.

I do not think that you will find much difference in the holding ability of the glue. The material will most likely fail before the glue.

Re: Interesting consideration gluing a edging

#5

Re: Interesting consideration gluing a edging

Thomas S Stockton

>Link,

I would definatly use a spline, biscut or domino on something like this. It would just add some mechanical strength to the joint. As for glue I would do the samples like you said and beat on them and see how they do. I was always told that poly glue did better on end grain then others, but there is so much advertising hype on the stuff that who knows what is right.

Tom