Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

A natural, durable finish with minimal coats and fuss popular among woodworkers, flooring professionals, and furniture makers

WC Weekend Accomplishments...

Posts

Re: WC Weekend Accomplishments...

#26

Re: cutting speed

Carol Reed - in Nebraska

>Well....probably not in the sense I think you are asking.

The info I posted was what I derived when routing with the CNC. Before that, I made special hold down jigs for the material and a specific guide system for the router, depending on what part I was routing.

To rout in the conentional router table is something I would think twice about. But that is me. When wood gets away from me it smarts. When aluminum gets away from me, it really hurts and always results in leaking blood all over everything. :)

Since at the time I was in production, I was motivated to get the CNC. I was routing an 1-1/2" hole and a 5-1/2" curved slot in the aluminum. I was also routing a long (10-12"?) 1/4" wide slot. The CNC reduced set-up and dramatically increased my success rate.

My sense was that the travel exertion of the router was significantly harder that when routing wood. It stood to reason (for me) that a very positive hold down and guide system was in order. So that is what I did. Also aluminum was, and is, expensive, so waste was not an option if it could be avoided.

Just my take. :)