Whoo-Whee, do I have a Radial Arm Saw!
Gary Evans Tallassee, TN
>Hi all,
A few weeks ago, I bought a used 3HP, 3PH, 14" RAS by Dewalt. Over the ensuing period, I have bought a 3HP VFD off e-bay. Thanks to everyone who chipped in advice regarding a way to drive this bad boy.
Today I finally got it wired up and it kicked off and ran just like it is supposed to! Whoopee!
I spent more than a couple of hours squaring the arm with the fence and then squaring the blade to the fence. I don't know the accepted wisdom, but I clamped down a framing square to the fence, used a drill bit as a feeler guage and then kept adjusting the angle of the arm to the fence.
I got it down to where the rip only varies from square, .0025" over 16". I measured this by cutting a piece of 16" wide plywood, flipping it over to cut about 1/4" off the same edge on the opposite side of the blade and indexing the same edge to the fence. The piece I sawed off varied from end to end by .005". Since the error off-square is doubled by this method, my actual error looks to be .0025". I'm normally not that compulsive, so I figure I just got lucky. 8^}
Now all I need is a good 14" blade. I asked about this a couple of weeks ago and was told that a negative hook angle and an ATB grind is optimal for a RAS cutting primarily green wood.
It seems that the only 14" negative hook blades that I can find are triple-chip grind, designed for use with laminates. Does anyone have experience using a 3chip grind on a RAS? I don't need a glue-joint surface. I just need it to be relatively smooth, without burning. Of course, the other consideration is that I need this to be a combination blade, so that I can rip or crosscut as efficiently as possible. Doable or not?
Thanks,
Gary



