Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Black dye

Posts

Black dye

#1

Black dye

eliot d

>I put some Fieberg's USMC black leather dye on a piece yesterday. It has a flat black look to it. Is there a way to give it a slight "lift" -- not a high gloss, but maybe a nice burnished look? Mike Gardner showed our club some pieces done with this leather dye; his finish looked better than mine!

Re: Black dye

#2

Re: Black dye

john lucas

>Eliot Almost all finishes will change it. You need to run a test. Krylon Fixatif may not change it much but on some things it does. I would definitely test this. Krylon Matte spray usually works to smooth it out. I want more sheen so I usually spray it with gloss lacquer and then knock it down with steel wool or abrasive pads. That may be more sheen than you want.

Re: Black dye

#3

Re: Black dye

eliot d

>John, Thanks; I meant to post this on the Turning site. But it doesn't matter. Your response is enough.

Re: Black dye

#4

Re: Try black shoe polish

Glenn Madsen near San Francisco

>on some scrap treated the same way. That may work for you.

Re: Black dye

#5

Re: Black dye

Robin Corell in Atascadero Ca

>I'm partial to fiebing's leather edge dye. it is an analine dye and comes in a container with an applicator top. I have used General's HP poly as a top coat when I want a glossy finish and for a more satin sheen I wipe on a coat of Jasco tung oil. neither of these finishes will react with the leathe dye. I did have problems with deft when using a brush and it looked a tad cloudy.

Robin