Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Support WoodCentral when buying things you need

Qujestion on Sharpening devices

Posts

Re: Qujestion on Sharpening devices

#26

Second the hollow grind/ jig-free honing *LINK*

Bruce, a MN Galoot

>Joel has a really good tutorial on his site, linked at the bottom here. The author, Maurice Fraser, uses a hollow grind, but doesn't specifically call it that.

But in addition to this, Bill, just how many people do you think have flitted from one method to another without stopping to master the technique at hand? All of them work, to a greater or lesser extent, but I think what people are looking for is instant success /gratification.

Can't happen.

I've always used a hollow grind, except for my very narrowest chisels.

I have an Eclipse jig that doesn't get used anymore, once I set my mind to learning to hone without it. If absolutely nothing else, jig-free honing is a lot faster.

Also note that this would have been a much different discussion over on the handtool side.

Bruce, still looking for a suitable piece of cast iron.


Sharpening tutorial

Re: Qujestion on Sharpening devices

#27

Re: Prices Mixed Up?

Doug Ridley

>I just ordered the WS2000 and will post on here when I get it. I plan to use it almost entirely on carving tools. Hope I didn't buy a pig in a poke.

Re: Qujestion on Sharpening devices

#28

Re: Hollow grinds verses flat grinds

Derek

>Denis,

As you know, after a hollow grind is performed, the next step is to hone a microbevel on the edge to get a good sharp edge. I believe that this microbevel eliminates the support issue from a practical standpoint. There is material removed from the blade a little way from the edge (i.e. 1/64" away), but I can not believe that it will affect the strength of the steel in most plane blades or chisels if the microbevel is even 1/64" long.

I confess that I do not own Japanese chisels or blades, so they may not be able to handle the lack

I also do not believe that a thin or thick blade is material to the discussion since the arc is determined by the wheel diameter and the fact that the blade is thicker and has a wider arc (longer cord) will not effect the steel geometry at or near the edge.