Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

Dust Collector Filter

Posts

Dust Collector Filter

#1

Dust Collector Filter

Ken Krawford

>I have a Bill Pentz design cyclone with a Wynn Environmental cartridge style filter. I have never cleaned the cartridge and it is time. A couple of questions:

Can it be cleaned or does it have to be discarded?

What's the best way to clean it? The air/dust enter the center of the cartridge.

Thanks.

Re: Dust Collector Filter

#2

Re: Dust Collector Filter

Phil Thien

>Most of the designs I've seen have a pan at the bottom of the filter (a mini "drop bin"). You blow the outside of the filter with low-pressure compressed air (I think 30-lb is suggested so you don't hurt the filter material) and allow the stuff to settle to the pan. After a few minutes you remove the pan and discard the contents.

You could also take the entire filter outside and blow w/ compressed air. May make quite a mess if it has never been done before. Oh, and you'll need to wear a mask if you do it outside like this.

Re: Dust Collector Filter

#3

Re: Dust Collector Filter *LINK*

Grant Smith

>Ken,

I suggest getting a "Webster" duster thing and using that to clean the inside of the canister. It is gently soft, but the many bristles will get between the pleats easily. Most of them have long handles or even telescoping handles.

I believe this type of thing is what Grizzly uses inside their canisters via a pull string (someone correct me if I'm wrong) to do a cleaning.

Regards,

Grant in Iowa


Webster

Re: Dust Collector Filter

#4

Re: Dust Collector Filter

Larry in NW Ohio

>Ken I have a Oneida and the filter is about ^ft. long and I cleaned it out one time. I closed off one end with a board and cut a hole in it for my shop vac and took it outside and laid it down and blu compressed air from the other end and from the outside in and just gave it a good cleaning. Larry in Ohio

Re: Dust Collector Filter

#5

Re: Dust Collector Filter

Jim Dillon

>Ken,

I also have the Oneida internal filter cartridge and clean it every 3 months or so. It is a NASTY job. Be sure to wear a good dust mask and pick a non-windy day! I very carefully remove the filter trying not to dislodge any of that really fine dust that is caked on, place the filter in a garbage bag, and tap it several times to get most of the major stuff off. Then I go outside and use an air compressor to blow the remainder off. I think Oneida recommends blowing only in the direction that the air normally flows through the filter, i.e. outside to inside - but I've also blown from the inside as well with no apparent effects. As filter materials can differ, it might be worth a call to the manufacturer to see what they recommend. Hope this helps.

Jim