Re: What material?
Eric Murphy - Spring TX
>This photo is of a chair from the Gamble House showing the ebony tsuba shape. Note the (what I assume to be) brass pins/nails around the edges of the tsuba.
Now, back to the holes in my piece of ebony. What I planned was to emulate the look of the brass pins seen in the chair photo. I have a couple of small chunks of osage orange that would fit the bill nicely in terms of color and "looking like" the brass pins. However, what concerns me about using a wood plug is when I sand, I want to get the true color of the wooden plugs, not the plugs stained by the black ebony dust created from sanding.
I've thought about the possibility of using something like a thin sheet of plastic with a hole so it fits over the plug and I'd only be sanding the plug, not the surrounding ebony. I've also wondered about using something other than the osage orange such as brass rod but then I see the issue as being getting a nice polished end on the visible end. Or, I also noticed that Penn State has yellow colored stabilized box elder burl pen blanks in their catalog. I don't know whether the stuff they use to stabilize would prevent the ebony dust from discoloring the yellow or not.
I would appreciate any suggestions that anyone could offer on how to achieve the look I'm going for while avoiding the issue with staining the plugs with ebony dust.
On other notes, I'm not particularly happy with the hole pattern I drilled in the ebony but the ebony is too expensive to start from scratch. I've come to live with it and accept it the way that it is. Also, the reason for the tape in the first photo is to mark each of the joints and the locations to drill for the square ebony plugs later on in the process.
