Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Precision you can feel — woodworking perfected with Lee Valley

New router table

Posts

New router table

#1

New router table

John D. Luke

>Wanted to share with you all my new router table I'm in the process of finishing.

It started out as a Rockwell over-arm router I got off of ebay several years ago. I got it pretty cheap since it was missing the original cast iron top and was replaced with cheesy particle board sink cut out piece.

I already had the sheet of 1" thick micarta that I had picked up from Boeing surplus and was hoarding for a future project.

Mounted the micarta to the over-arm and used this way for several years.

Recently I bought a second shaper for the shop and it was getting crowded in here, and I wanted to also get another router table to replace the old one that was starting to get beat up.

I than had an inspiration to combine the router table and over-arm router into one unit and trash the old router table and place the new shaper where the over-arm router used to be.

Got the Rockler large aluminum router plate and mounted it into the table, (lots of fun routing through 1" thick micarta)

The plate is mounted into the routed recess and I drilled and tapped 1/4-20 holes at each corner and screwed in 1/4-20 brass bolts for plate leveling.

The over-arm router fence is an old Delta small shaper fence mounted with 5/16 studs threaded into the micarta top.

The under table fence is a Jessem Master fence and the mounting rails are secured with 10-32 screws threaded into bottom of table top.

The white box on the lower left is a 220v contactor for the over-arm and next to it is a 110v switch for under table router and shop vac.

I have to use this for a while now to figure out where I want to attach a power feeder for the under table router. (I build a lot of tables and it works a lot better with a feeder to rout the edges of a 40" long sofa table)

This photo shows set up for over-arm routing

Questions and comments appreciated.


img

Re: New router table

#2

Re: New router table

John D. Luke

>And a shot showing set up for undertable routing


img

Re: New router table

#3

Re: New router table

Vijay Kumar

>John,

Looks very interesting. Would it be possible for you to post bigger detailed pictures or a link where we could look at details.

Vijay

Re: New router table

#4

Coming soon to Shop Shots - Stay Tuned

David Yoho

>

Re: New router table

#5

Re: New router table

Larry in NW Ohio

>Does this boeing surplus have a web site. I tried boeing surplus and just got a site to every place else but boeing. Thanks. Larry in Ohio

Re: New router table

#6

Re: New router table

John D. Luke

>Gee, I don't know what search engine you're using I typed in Boeing Surplus and got some 50,000 sites.

Anyway try the following http://www.boeing.com/assocproducts/surplus/retail/

Re: New router table

#7

Re: New router table *LINK*

Bob Lemon

>John, Your Rockwell overarm is also known as an Overhead Pin Router. Fixed pins or template guides can be mounted in the table to allow template routing.

I have built an inverted pin router that puts the router under the table and allows for better dust collection. I'm including a link to my site with describes how I built it.

Bob


Inverted Pin Router