Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Veritas - Innovation in Tools

Plant Stand

Posts

Plant Stand

#1

Plant Stand

Lee Brubaker

>This is a small project. A few years ago a friend gave me some Burr Oak which was harvested north of Winnipeg on the east shore of Lake Winnipeg & finally got around to using it.Finish is 4 coats of tung oil. Thanks for looking.

Lee


img

Re: Plant Stand

#2

Very nice Lee ...

mike farinella

>the scale and proportion are just right.

Re: Plant Stand

#3

Re: Plant Stand

albertabob

>Very nice Lee.

How did you joint the legs?

Bob

Re: Plant Stand

#4

Re: Plant Stand

Jim Shaver - Oakville, Ontario

>Nice Work Lee,

I like the shape and the design, the legs look nice. In another life I spent a lot of time in Manitoba, Winnipeg ,Selkirk the beach areas and points far north, I don't remember seeing too much hard wood then.

Again a nice project when you can connect the wood to a special place.

Take care,

Jim

Re: Plant Stand

#5

Nice Legs

Howard In Toronto

>Lee -

A masterful job.

Great proportions.

Howard

Tell us a little more about the joinery - the lower shelf, specifically.

Re: Plant Stand

#6

Re: Nice Legs

Lee Brubaker

>Thanks for the comments guys. Bob & Howard: The tops of the legs are notched to inset them in under the top shelf. I then scribed the curve of the shelf on the top of each leg & using a dremel ground the curve into the notch so that the legs nested snuggly to the circumference of the bottom section of the top shelf. The legs were dowelled and glued to the shelf.

The legs were formed with a flat section on the inside of the legs where the bottom shelf fits. The shelf was then notched 1/2" deep insetting the legs with the shelf at the flat sections on the legs. They are then dowelled & glued. The leg flats are 90 deg. to the bottom of the legs(feet) so that when the shelf is in place, there are no gaps between the legs & the bottom of the shelf notch at the underside of the shelf.Hope the explanation is not Greek.

Lee

Re: Plant Stand

#7

Re: Nice Legs

albertabob

>Very tricky joinery Lee.

It's especially difficult working on circular pieces like this as the geometry really plays tricks on you if you are not careful.

I have one like this on the back burner waiting for the right wood to come up so your info is very timely for me.

Thanks again

Bob