Sharpening spiral cut router bits
C Paxton
>Would appreciate opinions on both whether it is worthwhile and whom might do a good job. Realize that profile will be changed slightly - a very minor concern for me.
Knowledge You Can Build On — Est. 1998
Sharpening spiral cut router bits
C Paxton
>Would appreciate opinions on both whether it is worthwhile and whom might do a good job. Realize that profile will be changed slightly - a very minor concern for me.
Just buy new ones in solid carbide
Clint Searl, at the base of Haycock Mtn
>
Re: Just buy new ones in solid carbide
C Paxton
>The reason to (perhaps) not do so is that sharpening a solid 1/2" costs $14, whereas a new bit costs ~ $60-80. Looking at sharpening 4 bits, so potentially saving $200.
These are solid carbide bits
C Paxton
>
Re: Sharpening spiral cut router bits
Dale Lenz
>I've had mine sharpen by a local sharpening shop. Worked great, as you said, a few thousands difference was not a major problem in most work. I believe the sharpening guy told me it took a special machine. My local sharpening man is no longer in business, gotta find someone else, now.
Re: Sharpening spiral cut router bits
Tom Stockton
>I also have my local place sharpen them. There are a couple of different ways they can be sharpened some places can only sharpen the cutting end and this works well for a couple of sharpenings but to have a real nice job done the flutes need to be done as well.
like you said it gets expensive to think of these a disposable.
Tom
Re: Have you tried using end mills?
Al Crandall (N.E. of Indy)
>I'm not sure exactly what the differences are between solid carbide router bits and solid carbide endmills, but they might be worth a shot. They certainly don't cost $60 to $80 each. Probably a degree or two less clearance behind the cutting edge and a slightly different spiral angle. Locally, a 1/2" diameter carbide endmill is $19.25 each. At Enco, a 1/2" solid carbide endmill with 1" long flutes will cost you $17.99 plus shipping. Also available are endmills for aluminum with a faster spiral for faster chip ejection which might also work well for wood. Available with 5/8" and 1 1/4" flute lengths, they are priced at $23.99 and $26.49 respectively. I've sharpened spiral flute endmills as part of my training, and it does indeed take a special machine. Nothing wrong with "regrinds" if properly done, but the savings aren't what you are projecting. Be sure to tie down the regrind shop on delivery time.
Re: Sharpening spiral cut router bits
Larry in NW Ohio
>I have sent my sharpening things to Scott Whitting, who posts here once in a while, and does a very good job, the last time I sent some a few things and a spiral bit, to www.ridgecarbidetool.com and they also did a very good job. Nothing against Scott but I thing things from ridge were a little sharper. Larry in Ohio