Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Portable Sawmill & Tree Service – Abingdon, VA

Installing Peg Board

Posts

Installing Peg Board

#1

Installing Peg Board

Nick in St. Louis

>I am looking at installing pegboard in my shop over the weekend and I'm wondering if anybody has any hard learned tips. I will be going over bare studs that I'm going to add insulation between. The structure is a free standing single car garage that is at least as old as knob and tube wiring as I have found remnants (I have installed a new sub panel and proper circuits).

My main question is, should I glue/Liquid Nails the pegboard to the studs as well as screw, or will screws be enough?

Thanks for any advice, in advance.

Nick

P.S. I will also be installing 2 French cleats (high and low) so any pointers on that would be great too.

Re: Installing Peg Board

#2

Re: Installing Peg Board

Pat Evans

>If you mount directly to the studs, you will lose the use of all the holes that line up on the studs. I always drill mounting holes between the predrilled holes. Behind the mounting holes, I hot glue 1/4" sections of 1/4" copper tubing (just because I had scrap on hand) as spacers to hold the pegboard off the studs. With the spacers glued in place, I can mount the pegboard and screw it to the studs. Screws alone are sufficient.

Re: Installing Peg Board

#3

Re: Installing Peg Board

jeff

>Nick

I use the cheap pegboard in white from Home Depot.

I usually screw to the studs with a plain old drywall screw and washer (prevents the screw from pulling thru the hole.)

I only furr the boards out where I have a finished wall behind.

I haven't found the loss from the studs a problem.

As for the French cleats, they'll screw in fine, right to the studs.

I do that and also screw shelf standards right over the pegboard.

Jeff

Re: Installing Peg Board

#4

AMEN here ! . . .

s.mackay@worldnet.att.net

>Did it ! Still steams me over my own lack of prior planning. Wind up putting in nails to cover the spaces of the studs. Messes with my Chee !

Re: Installing Peg Board

#5

Re: Installing Peg Board

Jesse in New Mexico

>I use screws and washers.

Get some of these hooks - they absolutely will not come out!

http://www.leevalley.com/wood/page.aspx?c=2&p=50353&cat=1,43326,43327

Re: Installing Peg Board

#6

Re: Installing Peg Board

Brint in Atlanta

>If you pick up a "variety pack" of pegboard hangers at your local borg or hardware store, they often come with 4 or 6 or 8 of those spacers to keep the pegboard off your studs and all your holes usable. I'm just one of those unlucky types who always seems to find that the holes I most want to use for hanging a tool are those that are blocked out by the stud.

YMMV --