Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

This is the most versatile work station you will ever use

DC Bag MONITOR question?

Posts

DC Bag MONITOR question?

#1

DC Bag MONITOR question?

Barry Irby

>My DC is outside in a separate closet, so I have to walk out to check it occasionally.

I changed the setup to make the bag easier to change. I modified the stand for better access and raised it enough to allow a thirty gallon trash can to sit under it. I put the bag in the trash can and when I need to empty it I use a hand truck to roll the can away. The can is about four inches below the DC ring and I have to spot the dust when it gets to that space. I recently failed to notice it was full and filled it all the way into the filter bag. (Officially, that's a "blivet". 40 gallons of stuff in a 30 gallon can or five people in an MG.)

I looked on Bill Pents' site and there were plans for a monitoring device that involve a little fan. If the dust buried the fan, the blade stopped turning and set off the alarm. I'm not much on electronics and that seems complicated.

My first thought is to cut a slot in the side of the trashcan to give me a "view port". But I still would like a remote monitor to tell me when its full. Anyone got a better idea?

Re: DC Bag MONITOR question?

#2

Re: Hire an illegal alien to watch it.

Al Stokka - Cambrige, Iowa

>I haer they work cheap and can help when your ripping sheet goods. ;^)

Sorry Barry, I couldn't resist.

Re: DC Bag MONITOR question?

#3

Here is your solution . . . High Dust Alarm

Alan in Little Washington (NC)

>I had the same problem with my cyclone which is in a garage with my shop on the second floor. Below are two links to a simple, inexpensive, high dust alarm I built with off the shelf parts- little to no electrical expertise required. The first link has the write-up and pics (maybe more info further down in the thread. The second link has a simple wiring diagram and an idea to give yourself more free space at the top of the dust bin (you'll notice I had to install the sensor in the bottom of the cyclone cone, but if you have a dust bin instead of just a bag, it can be mounted in a section of duct attached to the top of the bin.) I was going to wait until I had submitted it to the WW mags as a tip before putting it on the WW forums, but haven't gotten around to it. Bill Pentz hasn't tested it but thinks its a good system.



High Dust Alarm

Dust Bin Level Mod

Re: DC Bag MONITOR question?

#4

Re: DC Bag MONITOR question?

Chuck Lenz

>You should be emptying your dust bag after each days use to prevent a fire, and it lets your bags breath the way they should.