Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

1/2" QSWO plywood from 1/4" QSWO plywood

Posts

1/2" QSWO plywood from 1/4" QSWO plywood

#1

1/2" QSWO plywood from 1/4" QSWO plywood

Ed in Lawrence, KS

>I'm making some prairie chairs that require 1/2" QSWO plywood. I'm having trouble locating 1/2" but can readily get 1/4" in either MDF or veneer core. I was wondering if there were any drawbacks to laminating 2 pieces of 1/4" to make the 1/2"? The 1/2" panels are to have edge rabbets with the tongue fitting into a slot in a panel and frame arrangement. I could just use 1/4", but I am concerned about the rigidity of the panel as the chair cushions will place pressure on them when someone is sitting in the chair. Any opinions are welcome. Thanks.

Re: 1/2" QSWO plywood from 1/4" QSWO plywood

#2

Re: 1/2" QSWO plywood from 1/4" QSWO plywood

Keith Newton

>It sounds OK for the back, but not for the seat.

Can you not use solid wood since it is in a frame?

Re: 1/2" QSWO plywood from 1/4" QSWO plywood

#3

Re: 1/2" QSWO plywood from 1/4" QSWO plywood

Dave Bair, Eaton Rapids, MI

>I trust this for the chair sides, not the seat. I'd feel confident that the glued panels' strength would be more than acceptable. However, two �" sheets won't actually give you a full �" thickness (actually, a �" sheet won't measure a true �" either). Use the actual thickness when machining your slot.

I've had problems getting consistant good bonds doing the same thing you're contemplating, so good luck.