Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Want Better Milling & Firewood Knowledge?

Sanding Epoxy finish?

Posts

Sanding Epoxy finish?

#1

Sanding Epoxy finish?

Bjorn - Redmond, WA

>For the first time ever (might be also the last time) I used Epoxy as a table top finish. While not a complete loss, it's not how I really like it. There were some bubbles and the recommended use of a propane torch remove the bubble, but create little craters. Now I wonder if I could sand the finish to make it a little nice, but don't won't to risk ruining it completely. Can it be sanded?

thanks,

--bjorn

Re: Sanding Epoxy finish?

#2

Re: Sanding Epoxy finish?

Jesse in New Mexico

>After it has hardened completely (a few days), sand it with 320 grit. Then 600 then 1200. If you like, you can then apply polish. I use automotive polish, lately Menzerna brand.

You can also put another thinned coat of epoxy on, and when it is half cured, cut on a thinned coat of varnish, then additional coats of varnish until you achieve the look you wish.

Re: Sanding Epoxy finish?

#3

Re: Sanding Epoxy finish?

Keith Newton

>Yes you can sand. You amy want to fill those open pores first with some grain filler, or whatever finish you follow this with, will be drawn into those holes as well.

Re: Sanding Epoxy finish?

#4

Re: Sanding Epoxy finish?

Phileas

>To prevent the bubbles from showing, try spreading the epoxy with a foam roller (which I suspect is your usual method) and let it set for just a little bit (5 minutes?). Then use a foam brush to go along the grain; this pops the bubbles and gives a nice smooth coat.

Cheers,

Phileas