Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Need a tree taken down or milled?

Bandsaw blade tune up question

Posts

Bandsaw blade tune up question

#1

Bandsaw blade tune up question

wilbur

>This weekend I noticed that my bandsaw blade moves backwards and forwards over about 1/8" along the line of the cut, within the cut itself. That is, if you stand to the side of the bandsaw and watch the back of the blade, it will move towards and away from the guide bearings that support the back of the blade during a cut. (Hope that was clear.)

My wheels are not completely coplanar, but they don't seem to be bent and I don't think there are any axle or bearing problems.

I'm not overly concerned, as it seems to cut straight enough. But is there a way to reduce this movement?

Re: Bandsaw blade tune up question

#2

Crack?

Ed Mulligan, Cape Cod

>That motion will happen if the blade has developed a crack. If so, replace it immediately. Ed

Re: Bandsaw blade tune up question

#3

Re: Bandsaw blade tune up question

Larry Clinton At Frankfort (Central)., Indiana

>During the cut the blade will move back to the rear thrust bearing of the upper and lower guides. I have a MiniMax MM16 and after centering the blade on the wheels, I adjust the thrust bearing about 1/32 to 1/16 clear of the rear of the blade when the saw is running (without cutting). The blade will move somewhat and thinner blades ( 1/8 & 1/4) will also flex in that direction when cutting. Higher tension will reduce the "flex", but isn't necessary if your cutting straight. Doesn't sound like you have a problem if it is cutting straight.

Re: Bandsaw blade tune up question

#4

Clarification

wilbur

>I should have made clear that I am seeing the back and forth movement when the blade is moving freely. I do have my guides set up pretty much identically to what you describe.

Re: Bandsaw blade tune up question

#5

Re: Bandsaw blade tune up question

Tony Ward. Blue Mountains, Australia

>If you are looking for additional information ~ Bandsaws and Blades information sites

Tony Ward

Re: Bandsaw blade tune up question

#6

Re: Bandsaw blade tune up question

Mark Kauder, Phenix City, AL

>I slighly bond a blade once in a green piece of wood, and afterword it did the same thing. Seemed safe, and cut fine, for none precision cuts.

Mark

Re: Bandsaw blade tune up question

#7

Kink

Garrett in Victoria BC

>Unplug, then rotate the wheel by hand. When you see a section of the band move either forward or backward in relation to the guides, mark it with a piece of chalk or a marker pen.

Continue rotating.

If it's always and only the same section that's moves in this way, the band probably has a kink in it from having been twisted or stretched. Nothing you can do about it other than keep that band for rough cuts.

Cheers, Garrett

Re: Bandsaw blade tune up question

#8

Re: Bandsaw blade tune up question

Tom Stockton

>Usually if it is a front to back motion it is a blade that was welded wrong . side to side tends to be from kinks although most the blades I've kink do both and get thrown out. Look at the weld closely and like another poster said if you see a crack pitch it.

Bottom line is if you are getting an acceptable cut and it isn't cracked keep using it.

Tom

Re: Bandsaw blade tune up question

#9

Thanks! it was the blade, ordered new ones

wilbur

>Thanks to everyone! Garret's suggestion to mark the blade made it clear to me what was going on. I used this as an excuse to finally get off my duff to order some new bandsaw blades.

I bought my bandsaw used back in the late fall, and just got it set up about one month ago. The blades I'm using all came with the saw, and I was holding off on ordering new blades until I was sure I had the bandsaw tuned up.