Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Build it. Rock it. Rockler has your woodworking tools.

OT removing a few 12x12 floor tiles?

Posts

OT removing a few 12x12 floor tiles?

#1

OT removing a few 12x12 floor tiles?

Steve Silca

>I want to regrout some installed floor tiles a different color. While I'm at it, there are three or four floor tiles that were very poorly installed (they are nearly 1/4" above the rest of the tiles). I plan to pull as much of the grout out as possible with a grout saw (any hints you have on that?), and while I'm at it I thought I would replace the bad tiles as well - I have a supply of matching tiles in the basement. Any tricks or words of advice for removing an individual 12" floor tile?

Re: OT removing a few 12x12 floor tiles?

#2

Inside out

Mark Goodall - ATL - tooljunkie

>Having done this myself several times, I've found that want to first remove the grout and then hit the tile in the center and break it apart from the inside towards the edges. Removing the grout creates a air gap between the tile and the surrounding ones you don't want to touch. Working from the inside will help avoid damaging the edges of the other tiles.

Smaking the tile in the center should crack it into 2-3 pieces, and then using a masonry chisel (again) from the inside should do the trick.

I also inserted some thin (less than 1/4") plywood in the "moat" upright between the tiles to help prevent damaging the other tiles.

Happy Woodworking!