Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

VPS-Level Performance. Fully Managed. No Hassle.

Yellow glue & danish oil

Posts

Yellow glue & danish oil

#1

Yellow glue & danish oil

Barry Rubenstein

>I completed a project and the finish is danish oil, but now see that I have to glue one more thing. If I let the oil dry (a week ?), will the glue hold ?

Re: Yellow glue & danish oil

#2

Probably not..

Mike in Paradise

>Depends on exactly what you are trying to do. Give us some more detail.

At a minimum you are going to have to sand the surface but the problem with oil is that it sinks into the wood.

I keep my work bench oiled so that I can easily pop off the glue spills.

Re: Yellow glue & danish oil

#3

Re: Probably not..

Barry Rubenstein

>I have to put little screw covers over countersunk screws; the covers will "span" over onto the wood about 1/8" all around. I guess I could use a 2 part epoxy; that would drip into the Phillip screw "cross" and add to the holding power.

Whaddya think of that ?

Re: Yellow glue & danish oil

#4

Bazooka Joe Bubble Gum..

Mike in Paradise

>Do they still make it?

Seriously that is a very low stress application. Most of the buttons that I have installed have a taper and pretty much friction fit reasonably well.

Epoxy will work but I would probably use a drop of silicon so I could easily scrape it out if at some point in the future if I needed to get back at the screws.

Re: Yellow glue & danish oil

#5

Re: Bazooka Joe Bubble Gum..

Barry Rubenstein

>Are you asking if 2 part epoxy is still made ? Walmart sells it in a double syringe arrangement; one side is hardener and the other is resin.

Re: Yellow glue & danish oil

#6

No..LOL

Mike in Paradise

>Not epoxy...Bazooka Job Bubble gum LOL