Delta Table Saw 34-300
Webster Stump
>Would anyone have any kind of info on this saw. Maybe some kind of experiences with it. Is it belt drive, if so, how well do it run and so on. Any advice would be great. Thanks
Knowledge You Can Build On — Est. 1998
Delta Table Saw 34-300
Webster Stump
>Would anyone have any kind of info on this saw. Maybe some kind of experiences with it. Is it belt drive, if so, how well do it run and so on. Any advice would be great. Thanks
Re: Delta Table Saw 34-300
Barry Irby
>I have a Delta/Rockwell 34-338. I imagine it's pretty similar. I have been using it for thirty six years. The original motor burned up so I replaced it with a 2Hp Dayton motor. Other than that and the fact that I have added dust collection, its pretty much original. I have been happy with it.
Re: Delta Table Saw 34-300
Webster Stump
>Barry,
Have easy are the parts to find for this saw?
Re: Delta Table Saw 34-300
Barry Irby
>The only part I have needed was the "body" for the clamp that holds the far end of the fence. The original was plastic and it broke after about thirty five years. The replacement came for the local repair shop that ordered it from Delta. It was metal and cost about $30. I thought that was a bit high, but to be able to get aprts for an old saw is worth a lot.
Re: Delta Table Saw 34-300
Doug
>I have no experience with this saw, but to check avaliability of parts check Delta's site or www.sawcenter.com