Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

100+ Wood Species + Full-Shop Services: Lumber, Veneer, Tools & CNC. Everything in One Place.

OT Installing a tin roof question?

Posts

OT Installing a tin roof question?

#1

OT Installing a tin roof question?

Barry Irby

>Does anyone know where the nails go in "5 V" agricultural tin roofing? This is the type with two Vee ridges on each edge and one in the center. Do the nails go through the top of the Vee's or in the Valley between them? Where can I get written intructions on this?

Re: OT Installing a tin roof question?

#2

Re: OT Installing a tin roof question?

John Veerkamp

>In corrugated roofing the nails go into the peaks, not the valleys. That way the holes made by the nails will shed water even if the neoprene seals fail. If installed in the valleys they will always leak.

DAMHIKT

John

Re: OT Installing a tin roof question?

#3

Re: OT Installing a tin roof question?

Larry Marker in Alabama

>You nail through the top of the vee. If you nail in the valley, water can puddle there and leak through.

There are two kinds of nails. One has a rubber washer on it and the other kind has no washer but has a thick lead head. If you have the rubber washer type, drive the nail hard enough to put the rubber washer under compression, but don't mash the tin vee flat. With the lead head nail, drive it hard enough to flatten the head against the tin, but again don't mash the tin flat. Your goal is to create a seal between the nail and the tin without seriously deforming the vee.

I don't know where you can find written directions.

Larry

Re: OT Installing a tin roof question?

#4

Re: OT Installing a tin roof question?

Clint Searl, at the base of Haycock Mtn

>Use self-tapping screws with rubber washers through the tops of the vee's.

Clint

Re: OT Installing a tin roof question?

#5

I always put'em in the top of the Vee. But.....

Basil

>...all the houses with the metal roofs around here these days have the nail (or screw) with rubber washers in the flat part of the tin. "They" say that's the way it's supposed to be done. The tin is supposed to last 50 years, which I don't doubt, but I have some doubts about that rubber washer.

I'm sticking to the old, 'put it in the top of the Vee' method. When the rubber gets old and brittle and breaks away from the nail, I think it will be less likely to leak or leak less in the top of the vee.

Someone already mentioned the old lead heads and how to use them.

Re: OT Installing a tin roof question?

#6

Re: OT Installing a tin roof question?

Dale Stansbery

>Check with the supplier. They generally have installation instructions.