Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

Exotic Hardwood, Personally Sourced Worldwide. Inspected at Origin. Shop Rare Stock.

installing wide board flooring

Posts

installing wide board flooring

#1

installing wide board flooring

Dale Stillman

>We have approx. 3,000 sq. ft. of 'large leaf' Maple. This is 5/4 rough cut random width & length. Came from trees fell on my daughters property near Seattle. We would like to finish some of this for hardwood flooring. Would like to re-saw to finish of 1/2" but will probably have to stay w/3/4" thickness. This will be cut to widths of 4" finished (allowing for 1/4" tongue). Lengths 4', 2' & 1'. My ? is can this be laid over linoleum flooring which exists now in the kitchen of our Manufactured home? My intent is to use the nailing method thru the tongue for securing it to the floor. What problems may I face in the plans as described above? TIA for the help.

Re: installing wide board flooring

#2

Ellis Walentine

I'd say yes

Ellis Walentine

>First, 4" is not wide board flooring to me -- 24" maybe. But that's not the point. I suggest getting enough floor mastic to do the job, then clean the linoleum with a strong cleaner that will get any dirt, grease, etc. off of it, then lay down a two foot strip of mastic with a notched trowel and toenail your boards down like you suggested. Remember to leave expansion room at the sides of the room that are parallel to the flooring.

Ellis Walentine, Host

Re: installing wide board flooring

#3

Re: installing wide board flooring

Stve Evans

>The official response would be no, don't lay down over lino flooring. That being said, I've done it twice in the last 10-12 years and have had no problems so far. I just used a regular nail down schedule. YMMV

Re: installing wide board flooring

#4

Re: installing wide board flooring

Barry Irby

>As with the others, I would think you can do this. What does raise a question in my mind is the statement about "manufactured home". I would be curious about what they put under the vinyl. If it is real plywood or Oriented Strand Board (OSB) then you should be fine. However, I have seen some of theses houses with particle board under vinyl. This is frowned upon for vinyl and may not hold nails well enough for hardwood.

I believe I would use Ellis' suggestion of mastic in addition to nails.

You realize you must mill this stuff to consistent widths? You can�t have truly random widths. Also, I would bring the material in the house and let it acclimate thoroughly for several weeks or months. I have seen any number of air dried floors that were not as dry and not as well acclimated to the house as they should be and they develop cracks larger than necessary at the joints.

Re: installing wide board flooring

#5

Re: installing wide board flooring

Jim Dillon

>Dale,

While it is generally not encouraged, putting down hardwood flooring on top of linoleum flooring should be doable IF: 1) the linoleoum is in good condition and not peeling up from the subflooring, and 2) the subflooring under the linoleum is NOT particle board. If your subflooring is solid 3/4 inch plywood (and perhaps OSB although I am hesitate here), then I would go for it with the recommended addition by others of an adhesive under each board. If your subflooring is particle board, then it MUST be ripped up. This is a job from H*ll. I've had to do it on our whole house and I thought I was going to have a heart attack, especially where there was linoleoum on the floor. Ended up setting a circular saw to just a tad over 3/4 inch and cut the linoleoum/particle board into 1 foot squares and then prying up the pieces with a massive crowbar.

On another note. You mentioned 1, 2 and 4 foot lengths. Why so short? It is best if you can span the floor joists so the flooring nails can go directly into the joists or at least end at the underlying joist. And try to avoid the "H" pattern to make it look better. There is a book published by Tauton Press on laying hardwood flooring that, IMHO, is excellent. My 2 cents and good luck.

Jim