Home Articles Forums Gallery Marketplace Videos

WoodCentral Forums

Knowledge You Can Build On — Est. 1998

200+ woodworking book reviews

Square drill... round hole

Posts

Square drill... round hole

#1

Square drill... round hole

Pat Evans

>The mortising machine I acquired from my Dad had two sets of bits, one of which is a Craftsman. Neither set will drill perfectly square mortises. The tips of the bits are very slightly larger than the width of the chisel. Each side of a mortise has square corners, but a slight concave groove down each face. There is enough flat that it won't affect the fit of a tenon, but it sure is ugly. Do all mortise bits do that, or should the sides be completely flat?

Re: Square drill... round hole

#2

Re: Square drill... round hole

Larry Marker in Alabama

>My Jet chisels are flat and square. My bits can be raised higher than the tip of the chisels, so they can't be larger than the chisel.

Larry

Re: Square drill... round hole

#3

Re: Square drill... round hole

Tony - Memphis

>I would be concerned that you are giving up that much glue surface. I have a Powermatic benchtop and use their chisels (Jets) are bigger than the bits for sure.

Tony